132984980.qxd 23/09/2005 16:45 Pagina 31
LevellingWater drainage
Carefully level by screwing the adjustable feet in orThe end of the drain hose can be positioned in three
out. Never place cardboard, wood or similarways:ENGLISH
materials under the machine to compensate for any
Hooked over the edge of a sink using the plastic
unevenness in the floor.hose guide supplied with the machine. In this
case, make sure the end cannot come unhooked
when the machine is emptying.
This could be done by tying it to the tap with a piece
of string or attaching it to the wall.
Water inlet
Connect the water inlet hose supplied with the
machine to a separate tap with a 3/4" thread.
Do not use already employed hoses.In a sink drain pipe branch. This branch must be
above the trap so that the bend is at least 60 cm
The other end of the inlet hose which connects to theabove the ground.
machine can be turned in any direction. Simply
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks.
Directly into a drain pipe at a height of not less
than 60 cm and not more than 90 cm.
The end of the drain hose must always be
The inlet hose must not be lengthened. If it is tooventilated, i.e. the inside diameter of the drain pipe
short and you do not wish to move the tap, you willmust be larger than the outside diameter of the drain
have to purchase a new, longer hose speciallyhose.
designed for this type of use.The drain hose must not be kinked. Run it along the
floor; only the part near the drainage point must be
raised.
31 |