Clock/Timer
English
2Press CD, TUNER or TAPE to select the
desired source.Sleep Timer Setting
Before setting timer, make sure the music sourceThe sleep timer enables the system to switch to
has been prepared.Standby mode automatically at a preset time.
CD Load the disc(s). To start from a specific1Press SLEEP on the remote control repeatedly
track, make a programme (refer to CDto select a preset time.
Operation - Programming the disc tracks).� The selections are as follows (time in
TUNER tune to the desired radio station.minutes):
TAPE load the prerecorded tape into tape15 " 30 " 45 " 60 " OFF " 15
deck 2.� "SLEEP XX" or "OFF" will be displayed. "XX"
3Pressa or á on the system repeatedly to setis the time in minutes.
the hour for the timer to start.2When you reach the desired length of time, stop
4Pressà or ë on the system repeatedly to setpressing the SLEEP button.
the minute for the timer to start.�SLEEP will appear on the display, except for
5Press CLOCKYTIMER to store the start time."OFF" mode.
� "TIMER ON" will be displayed and followed� The Sleep Timer is now set. Before the
by the set timer "XX:XX" and then the selectedsystem switches to standby mode, a countdown
source.of 10 seconds will be displayed.
�TIMER will remain on the display."SLEEP 10" " "SLEEP 9".... " "SLEEP 1"
At the preset time, the selected source will play." "SLEEP"
To exit without storing the settingWhile SLEEP mode is activated
Press �on the system.To check the remaining length of time
Press SLEEP once.
Notes:
� If the selected source (CD) is not available whenTo change the preset sleep timer
preset timer is reached, TUNER will be selected Press SLEEP twice.
automatically.� The display will show the remaining time
� During timer setting, if no button is pressedfollowed by the sequence of sleep timer options.
within 90 seconds, the system will exit timer setting
mode automatically.
To deactivate the Sleep Timer
To deactivate the TIMER Press SLEEP repeatedly until "OFF" is displayed,
or press the STANDBY ON button.
Press TIMER ON/OFF on the remote control.
� The display will show "CANCEL" and TIMER
will disappear from the display.
To activate the TIMER
Press TIMER ON/OFF on the remote control.
� The last set timer information will be shown
for a few seconds and TIMER will appear on
the display.
26
3139 115 20581
pg 001-029/C700-C780/22-Eng263/7/01, 3:50 PM |
ACEC
PHILIPS
