94000-gb.fm5 Page 17 Thursday, September 13, 2001 4:13 PM
HOW TO USE THE DISHWASHER
Close the dishwasher door and turn on
the water tap.
1
1. Press theON/OFF bu tton to switch on the
dishwasher. One of the programme indicator
lamps will illuminate.
2. Select the required programme by pressing
the programme button. The corresponding 2
indicator lamp will illuminate.
If required, select any additional functions.
3. Press theStar buttotn to start the selected
wash programme. The corresponding 3
indicator lamp will illuminate. Once set, the
programmed data cannot be altered by
turning the programme selector knob or
pressing the buttons.
Note: Once the Start button has been
pressed, the dishwasher memorises all the
programmes selected. The selected
programmes are also saved in the event of 4
power failure.
4. To change the programme selected, press
the Star buttton for about 5 seconds until the
Star indticator lamp switches off. Select a
new programme using thprogramme e
button and press thStare .t
5. The End indicator lamp (if fitted) illuminates 5/6
briefly and Starthe indictator lamp switches
off to indicate the end of the programme.
6. Press theON/ OFF button to switch off the
dishwasher (only after theEnd indicat or lamp
has switched on or the Startindicator lamp
has switched off). All the indicator lamps
switch off.
Note: If the dishwasher is switched off
during a wash programme, when switched
on again the dishwasher resumes the wash
cycle from where it was interrupted.
Open the door and unload first the lower rack
and then the upper one.
17 |
ACEC
BAUKNECHT
