D BLS (Blank Skip)information, read through chapter ODSCI GEO
Use this function to skip blank sectionsprogramming�.To adjust the Balance (left/right) and
of the tape.Fader (front/rear) settings.
As soon as an unrecorded portion ofG LD (loudness)
more than 15 seconds is detected du-
Use this function to boost the low fre-Fader front
ring playback, the system will automati-quencies for more bass, especially at
cally forward the tape to the beginninglow volume levels.
of the next title.To switch LD on/off: Press the button.
In this case, the display will show
For more information, see chapter
OCPS-FF�.ODSC programming�.BalanceBalance
To switch BLS on/off: Press the BLSleftright
button.
When the function is active, OBLS� willH AUD
To adjust the treble and bass frequen-
light up in the display.cies using the rocker button.
Fader rear
E loTreble
To change the seek tuning sensitivity.+The last setting will be stored automati-
lo lit up in the display indicates normal
seek tuning sensitivity (the system willcally.
If the setting remains unchanged within
pick up all powerful, nearby stations).8 seconds, the display will switch back
lo off indicates high seek tuning sensiti-Bass+Bassto be previous indication.
vity (the system will also pick up wea-
ker stations).J RT � Radio text
To change the seek tuning sensitivi-
ty: Press lo.Use this function to display message
Trebletexts transmitted by an RDS station. RT
messages will only be displayed if the
F DSC (Direct Software Control)ignition is switched off.
Use the DSC function to adapt a num-The last setting will be automatically
ber of programmable basic settings tostored.To switch RT on/off: Press RT.
If the setting remains unchanged within
suit your listening preference. For more
8 seconds, the display will switch back
to the previous indication.
26
Hamburg RCM 104 |
ACEC
BLAUPUNKT
