How to proceed if ...
Open the door.
Pull the filter upwards.
Open the filter.
Clean the filter at the end
Brush lint using a soft brush or your
of every cycle.fingertips.
Close the filter.
Push the filter back into place.
Pull the handle to remove the water
...you want to container.
Empty the water container Empty the water container.
correctly care for
and clean your at the end of each drying Replace the water container when empty
cycle.by pushing it completely back in place.
dryer:
Remove fibres in and around the water
evacuation hole at least once per month.
Clean the heat exchanger
at least every month.
(For further information
see chapter ?Heat
Exchanger? in the
Instructions for Use).
Has the correct drying programme been
selected?
Was the inserted laundry too wet
(washing machine spin speed less than
1000 rpm)?
Drying takes too long / Is the lint filter dirty (filter indicator light on)?
Is the heat exchanger dirty? (for more
laundry is not dry enoughinformation, refer to the instructions for use)
Is the room temperature too high?
Are the END ?? and Anti-crease
?? indicator lamps lighting
up? The drying cycle is complete and the
laundry can be taken out.
...you want to check the
dryer yourself first: Is the plug properly inserted into the
mains electricity socket?
(If your machine is not The dryer will not operate Is there a power failure?
functioning correctly, please (after a power failure, Has the fuse blown?
check the following points always press the Is the door properly closed?
before phoning for the ?Départ (Pause)? button). Has a drying programme been selected?
customer service - also refer Has the ?Départ (Pause)? button been
to relevant chapter in the pressed?
instructions for use) Is the lint filter clean?
Lint filter or water Is the water container empty?
container indicator lamp Has the water container been inserted
on.correctly?
Is the heat exchanger clean?
Has the heat exchanger been inserted
correctly?
Has any fluff on the heat exchanger seal
Water droplets underneath been wiped away?
the dryer. Has any fluff on the door seal been
wiped away?
Has the water container been inserted
correctly?
AFTER-SALES SERVICE
If the fault is still present once the above checks have been undertaken or should the fault occur for a second time, switch the
machine off. Please contact your after-sales service representative (for more information, refer to the warranty manual).
Please have the following details ready when calling your after-sales service representative:
the nature of the fault.
the dryer type and model
the service code (the number after the word Service on the adhesive
rating plate) on the right-hand side when the door is open.
3 |
ACEC
