13th January 1995SERVICE PROGRAM MODE
2.5 SP5-803 SENSOR/SWITCH INPUT SIGNAL DATA CHECK
1. Access SP5-803 (refer to section 2.1).
2. Select the required 3rd level program number using the and
keys. See the following page for a list of which 3rd level number
to use for each component.
NOTE: Do not press after selecting the 3rd level program
number or this SP mode will not operate.
3. If you want to check the signal during the copy cycle, enter the number of
copies in the copy counter and press the Start key.
4. The reading ("0" or "1") will be displayed in the reduce/enlarge indicator.
5. To check the reading from another sensor, switch, or signal, repeat from
step 2.
3rd levelReading
Sensor/Switch/Signal
No.01
1Upper Relay SensorPaper not detected Paper detectedService Tables
2Lower Relay Feed SensorPaper not detected Paper detected
33rd Tray Paper Feed SensorPaper not detected Paper detected
(Paper Tray Unit)
44th Tray Paper Feed SensorPaper not detected Paper detected
(Paper Tray Unit)
55th Tray Paper Feed SensorPaper not detected Paper detected
(Paper Tray Unit)
6Registration SensorPaper not detected Paper detected
7Fusing Exit SensorPaper not detected Paper detected
8By-pass Feed Paper Width SensorSee the Note after the end of this table.
9By-pass Feed Paper End SensorPaper detectedPaper not detected
10By-pass Feed Table SwitchTable is closed Table is open
11Upper Tray Paper End SensorPaper detected Paper not detected
12Upper Tray Upper Limit SensorDown Up
13Not Used--
14Upper Tray SwitchNot setSet
15Lower Tray Paper End SensorPaper detected Paper not detected
16Lower Tray Upper Limit SensorDownUp
17Not Used--
18Lower Tray SwitchNot setSet
191st Tray Paper End SensorPaper detectedPaper not detected
(Paper Tray Unit)
201st Tray Upper Limit SensorDownUp
(Paper Tray Unit)
4-43 |
ACEC
