SECTION FOUR - TUTORIAL
Warp the Green and Red Channels Together
When we have the Amps and Cabinets in our Green and Red Channels dialed in to suit our taste, we can Warp
them together to create our new HyperModela. Make sure your GNX1 is in yellow mode (indicated by the Status
LED lighting yellow). If it is not in yellow mode, press the Status or Exit button until yellow mode has been
accessed.Then rotate the Number 3 (Warp) Knob to achieve the desired blend of the Amps and Cabinets in our
Green and Red Channels.
Save the HyperModela
Now that we have designed our own Amp/Cabinet HyperModela, we need to save our creation to one of the 16
User HyperModela locations.This will enable us to use it in Presets. Press the Amp Save button once.The
Display will read NEWAMP (New Amp) and the first letter (N) will be flashing.This is asking us to name the new
HyperModela. For the sake of this example, letOs name the HyperModela ORectwd� (Rectified Tweed). Press the
Data Up/Down buttons to select R as the first letter.Then press the Rhythm button to select the next charac-
ter in the Display.This character should already be an E because we started out with the name ONEWAMP.� If it is
not an E, press the Data Up/Down buttons to select E as the character. Continue to use the Rhythm button to
select the next character location in the Display, and the Data Up/Down buttons to select the alphabetic charac-
ters until the Display reads RECTWD.
Then press the Amp Save button again.This will take us to the second step of saving a HyperModela, which is
choosing one of the 9 User HyperModela locations.The alpha-numeric Display should read EMPTY (Empty) and
the red numeric Display should read U1 because this is the first HyperModela stored to your GNX1. Press the
Amp Save button again to store this new creation to this Amp location.The Display will briefly read AMPSVD
(Amp Saved) and then return to showing the name of the currently selected Preset.
Assign Models to the Preset Channels
In the previous steps, we assigned a Tweed to the Green Channel and a Rectified Model to the Red Channel.Then we
Warped the two together to create our HyperModela.This HyperModela is now saved as an amp type that we
named Rectwd, but it is not currently a part of our Preset. In this example Preset, we were going to have the ability to
toggle between an acoustic guitar simulation and our new HyperModela.To do this we need to assign the acoustic
model to the Green Channel and our new Rectwd to the Red Channel of our Preset.The LED next to the Status but-
ton should currently be yellow. If it is not, press the Exit button. Now rotate the Number 1 Knob until the Display
reads ACOUST.This is the Green Channel Model for the Preset. Now rotate the Number 4 Knob until the Display
reads RECTWD (our new HyperModela).This is the Red Channel Model for the Preset.We will now be able to toggle
between these two sounds using the Amp Footswitch.
27 |
ACEC
