125992233 gb.qxp 2005-04-25 11:07 Page 53
Operating sequence
Before using your tumble dryer for the first time, weAfter each use
recommend to place a few damp cloths inside the
appliance and dry for 20 minutes.? Switch the appliance off by releasing the ON/OFF
ENGLISHThere may be dust inside a brand new tumble dryer. button . The mains-ON light goes out.
? Clean the filters (see page 55).
? Empty the water reservoir (see page 56).
Drying
1. Connect the appliance.
Important!
2. Open the door.If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
time selector dial to position (cooling) and wait
until the end of this phase
before removing the laundry. This will avoid a build-
up of heat inside the appliance.
Modifying the programme
To change a programme which is running without
opening the door, first depress the ON/OFF button
3. Load the items one at a time, shaking them outand then turn the time selector dial to the
loosely.required time. Press the ON/OFF button again and
4. Close the door. Please check the laundry doesthen the Start button .
not get caught between the door and filter.
5. Press the ON/OFF button : the mains-ON light
comes on.
6. Select the drying time.
7. If required, press the Low Temperature button
or the Cool Tumble button .
8. Press the Start button , the machine starts
operating.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase (position on selector dial).
The machine stops
automatically at the end of this phase.
9. Release the ON/OFF button (the mains-ON light
goes out) and immediately remove the laundry.
53 |