125981580 gb.qxp 2005-09-21 07:08 Page 19
Something Not Working
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without
calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below.
During machine operation it is possible that one of the following messages appears on the display:
Problem with filters/condenser ......?Please clean filters/condenser? Please check filters/condenser.ENGLISH
Problem with water reservoir ........?The tank is full, please empty? Please check the water reservoir.
Door open ......................................?Can?t lock door? Please check the door.
Once the problem has been eliminated, press the START/PAUSE button to restart the programme.
IMPORTANT: if the ?Warning? message and an alarm code (e.g. E21) appear on the display and the buzzer
sounds, switch the machine off and call the Service Centre.
SymptomPossible causes
The tumble dryer does notIThe door(s) has (have) not been closed (?Can?t lock door?).
startIThe plug is not properly inserted in the power socket.
IThere is no current at the socket.
IThe main fuse or the fuse in the plug has blown.
IThe selector dial is not set correctly.
IThe water reservoir is full or not properly inserted (?The tank is full, please
empty?). The programme starts in any case but it stops after approx. 4 minutes.
IThe START/PAUSEButtonhas not been pressed.
IThe DELAY STARToptionhas been selected.
Drying takes too long orIThe laundry has not been spun properly.
laundry is not dry enough.IThe filters and/or the condenser are clogged up (?Please clean
filters/condenser?).
IThe water reservoir is full (?The tank is full, please empty?).
IThe room temperature is too high.
IThe selected time or drying cycle was not suitable for the laundry.
IThe HALF POWER option has been selected.
IThe HALF LOAD option has been selected.
IThere is too much laundry inside the appliance.
IThe dryer is not correctly installed.
The drum light
The Programme/Time selector dial is on position ?0?.
does not light up:
The lamp is defective.
If, after the above checks, there is still a fault, callThis information can be found on the rating plate
your local Service Centre.(see picture on page 4).
Please make sure you give the model and serial
number of the appliance.
19 |