125981111 gb.qxp 2005-03-07 08:39 Page 13
Clean it with a brush and rinse it under the shower ifsteam iron or to top up a battery, etc. In this case it
necessary.must be filtered (e.g. through a coffee filter).
ENGLISHCleaning the drum
When your laundry does not reach the desired
degree of dryness, in other words, when it turns out
either too dry or too damp, we advise you to clean
the inside of the drum with a cloth soaked with
vinegar.
Also clean the outside, removing all fluff.This will eliminate the slight patina that has formed
in the drum (due to residues of detergent and
Clean the rubber seal round the condenser cabinetsofteners used in the washing, and to the lime
and in the inner part of the small door with a dampcontained in the water), which prevents the probes
cloth.from detecting the correct degree of dryness.
Important! Do not use pointed objects or utensils to
clean the spaces between the plates, as this could
damage the condenser and make it permeable.
Re-fit the condenser, turn the red stops upwards
and close the door.
Do not use this appliance if the condenser
has not been fitted.
Emptying the water reservoir
Water extracted from the laundry condenses inside
the machine and is collected in a reservoir.
The reservoir must be emptied after each drying
cycle to ensure efficient operation when the
machine is next used. The pilot light ?Reservoir??
reminds you this operation.
Proceed as follows:
Pull out the reservoir
Turn it upside down and let water flow down
Re-fit the reservoir
The reservoir must be re-inserted correctly.
If this is not done the pilot light ?Reservoir? comes
on during next drying and the programme stops,
leaving the laundry damp. The buzzer will sound.
After emptying and inserting the reservoir the
START-button START/PAUSE has to be depressed
again to allow the programme to continue.
Handy tip: The condensed water may be used in a
13 |
ACEC
