ELECTROLUX EFi620G Instruction Manual

Fitting the Cooker Hood to the
Wall
1.Fit the brackets with the round ends facing
downwards using the plastic rawl plugs and
screws provided.
2.Once the brackets are secured, lift the hood
squarely to the wall slightly higher than the
brackets. Lower the cooker hood until it is
located onto the two brackets.
Ensure that the cooker hood is correctly
located before letting go.
3. Access to the two wall levelling screws is from
above the hood. These are located in the two
extension arms at either side of the hood.
Level the hood using the screws located in
each extension arm.
4.By loosening the screws at the front of each
extension arm the hood can be aligned with
the front of the adjoining wall cabinets.
5.The hood should be secured on each side to
the adjoining wall cabinets using the 4 x 15mm
(1/2 ins) security screws provided.
6.Adjust the lower spacer panel at the rear of the
hood to close the gap to the wall.
Decor Panel
The dimensions of the door panel should be
59.6cm (23 1/2 ins) wide by 35cm (13 3/4 ins) in
height.
Fitting a Decor Panel to the Hood
Visor
1.Remove the complete visor assembly by
pulling open into the operating position,
simultaneously press down on the release
catch located behind the visor on the left hand
side of the casing.
2.Using the paper template provided, mark the
screw hole positions on the reverse side of the
decor panel. Ensure that the paper template is
aligned with the top edge of the decor panel.
14