EME1925 U Englis h
Unpacking
N.B. When you unpack the oven, check that tThe oven,he parts of the oven or the accessories may
product is free from damage. Damage or any missinbe wrappged by a protection foil. If so, you must
parts must be reported immediately to the retremove tailer.his foil before using the oven. Do not leave
packing material so that small children can play with
it. This can be hazardous.
Installation.
1. Remove any promotion label from the door.Connecting to the mains
2. The oven should be installed on a flat, levelThe oven is delivered with the power cord and a plug
surface. The surface must be strong enough to
for 230V, 50Hz, earthed socket outlet.
safely bear the weight (13.5 kg) of the oven, andEarth protection minimises the risks should a short
the contents. To avoid the possibility of causing
circuit occur. Check to ensure the voltage of the oven
vibration or noise the oven must be in a stablematches the supply.
position.
N.B. If the oven is connected to the socket via an
3. Keep the oven away from heat and water.extension cord, make sure the cord is earthed.
Exposure to heat and water can lower oven
efficiency and lead to malfunctioning, so be sure
to install the oven away from heat and wmaterWARNING : This appliance must not
sources.be used on a non-earth protected power
supply. Contact an electrician if you are
4. Do not block air vents on the top and the sides ofuncertain regarding electrical connection
the cabinet and also do not place any articles onof the oven or provision of earth protection
the top of the oven. If air vents are blocked during
of the supply.
operation, the oven may overheat, and this may
lead to malfunctioning. Hot air escapes from the
vents, so be sure not to obstruct it or letm curtWARNINGains : This appliance must be
come between the oven and the rear wall.earthed. If this appliance is fitted with a
non-rewireable plug for which your socket
5. Place the oven as far away from radios and TVis?s unsuitable, the plug should be cut off
as possible. This oven does conform to EECand the appropriate plug fitted. If it is
requirements of radio interference suppression,necessary to change the fuse in a non-
but some interference may occur if it is placed trewireaboole plug, the fuse cover must be
close to a radio or TV, so keep them as far apart
refitted. If the fuse cover is lost or
as possible.damaged, the plug must not be used until
6. If positioned in a corner, leave a gap of at leasta replacement is obtained.
15 cm from the walls and 17 cm above the
microwave.m WARNING : It is hazardous for
anyone other than factory trained service
IMPORTANT! The oven can be placed almostpersonnel to carry out any service or
anywhere in the kitchen. Make sure the oven isrepair operation that involves the removal
placed on a flat, level surface and that vents asof a cover that gives protection against
well as the surface underneath the oven are not
exposure to microwave energy.
blocked (for sufficient ventilation).
m WARNING : If the supply cord is
damaged, it must be replaced by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a
hazard.
8 |
ACEC
