CLEANING BETWEEN THE OUTER ANDTO REPLACE THE OUTER GLASS
INNER DOOR GLASS
1. Open the oven door with care and place in the
park position at an angle of approximately 30°.Under no circumstances should the
door assembly be detached from the
product for cleaning. Please refer to the
cleaning instructions.
The outer door glass is removable for cleaning.
TO REMOVE THE OUTER GLASS
1. Open the oven door slightly to gain access to the
two cross head screws on the top of the oven
door.
2. Loosen the two screws using a Pozidrive2. Holding the oven glass with both hands, gently
screwdriver.place the locators into the holes of the brackets
at the bottom of the oven door.
3. Hold the door glass securely with one hand,
3. Push the top of the oven glass towards the oven
before removing the screws completely with the
other hand.door ensuring the screw location holes line up.
The screws and washers retain the trim on the
4. Ensure the trim is correctly positioned on the top
top of the grill / top oven door.oven / grill door.
Note the position of the trim on the door.
5. Hold the glass in place at the top of the door.
Insert the cross head screws into the location
Grill Door Trimholes. Give the screws one turn to ensure the
glass is secure.
6. Tighten the screws positively with the Pozidrive
screwdriver before closing the oven door.
DO NOT attempt to use the oven without the
glass being in place.
If the door glass panel becomes chipped or
has deep scratches the glass will be
weakened and must be replaced to prevent
the possibility of the panel shattering.
4. Using both hands, gently tilt the top of the doorPlease contact your local Service Centre
glass towards you. Lift slightly to disengage thewho will be pleased to advise further.
locators from the two bottom brackets. The door
will remain in a parked position at an angle of
approximately 30°.TO CLEAN THE INNER GLASS DOOR
PANELS
5. Clean the outer and inner glass using hot soapy
water or Hob Brite. DO NOT try to clean theClean the inner door glass panels using a soft cloth
and hot water to which a little washing up has been
aluminium foil which is inside the door. The foil is
there to help keep the door cool, if it is damagedadded. If the inner panel is heavily soiled, Hob Brite
it will not work. Ensure that all parts are wellmay be used. Do not use abrasive cleaning materials
rinsed and thoroughly dry before attempting toon the door glass. Ensure that all parts are well
replace the outer door glass.rinsed and thoroughly dried before attempting to
replace the glass.
28 |
ACEC
