lCarefully score down from each end of the cable
HOW TO FINISH UNPACKINGsheathing along the length of the bare earth wire
lPlace packed cooker next to the cabinet in which(if a cut was made along the length of the live or
neutral wires, it might cut into their sheathing) to
it will be installed.the cuts already made.
lRemove the cooker packing except for bottom
tray which should be left in position until thelCarefully prise open the sheathing at each end of
the cable to expose the encased wiring.
cooker is ready to be fitted into its cabinet.
NOTE: It is imperative that the appliance is leftTO REMOVE COVER OF MAINS TERMINAL
in the base to protect both the appliance and theFrom the rear of the cooker, remove mains input
floor.terminal cover to gain access to terminal block.
lEnsure the owner is given these operating
lFirst remove retaining screw with pozidrive
instructions.screwdriver. See Fig. 3.
TOOLS REQUIRED
The following tools will be needed and it helps to
assemble them before starting to install your oven:
A terminal screwdriver (3mm wide blade)
A pozidrive screwdriver
Pliers
Wirestrippers
Knife
Sidecutters
Adhesive Tape
Tape Measure
Fig.3
MAKE THE ELECTRICAL CONNECTIONSlPrise cover loose using screwdriver in position
(1) then lever off with screwdriver in position (2)
at either side. See Fig. 4.
Important: Switch off at mains, miniature
circuit breaker and, if appropriate, remove
fuse before commencing any electrical work.
PREPARING CABLE
We recommend you use a new length of cable to
ensure your safety.
lEnsure you have the correct length of cable
appropriate to the wiring method you are using.
When fitting new cable allow sufficient cable forFig.4
removal of the unit at a later date, should it be
necessary.
lScore, but do not cut through, around the
sheathing with a knife 100mm (4in) from each
end of the cable and break through to the
encased wires by bending the cable backwards
and forwards to fatigue the sheathing.
9 |
ACEC
