Changing the opening direction
of the doors
If you wish to change the opening side of the doors
proceed as follows:
1... Open the freezer door. All the appliances have a
ventilation socle at the bottom. Remove it pushing
strongly on the central and upper part. The upper
supports will be loosed takes the piece out. Then,
take the hinge cover off the opposite side of the
ventilation cover and place it as required. (see fig.
5).
2... Removing the central hinge:
Open both doors.
Remove the external pin and then close the free-
zer door.
Remove the other pin and close the fridge door.
Taking care the doors do not fall, pull them off till
bolts are loose.
Put the doors carefully on the floor.
3... Chage the bolts of the upper and lower hinges to
Fig. 5the opposite side. Change also the plastic covers of
the central partition.
4... Change the door self-closing system, putting the
freezer door?s on the fridge door and viceversa.
5... Fit the freezer door into the lower hinge bolt and
put the central hinge into the door.
6... Fit the fridge door into the upper hinge bolt. Pulling
both doors outwards, fit the central hinge bolt too.
Place the doors.
7... Open the fridge door and screw the central hinge
pin. Then, open the freezer door and screw the
other pin.
8... Assemble socle keep the door open, close it up to
the metallic part.
Fit the two lower flaps of the plastic piece into the
metallic one, press down wards the two upper
hooks (without stopping pressing the socle).
Push it to wards the metallic one till they fit per-
fectly.
9...Dismantle the vertical handles and assemble
them in the opposite side. Cover the holes with
the plastic lids that were situated where the handles
are presently.
Once finished make sure that all joints close per-
fectly well all around the door and check that the
internal light turns off when the fridge door closes.
(see Fig. 6)Fig. 6
23 |
ACEC
