MAINTENANCE AND CLEANING
Before any maintenance or cleaning work is carriedWhen the appliance is not in use
out, DISCONNECT the appliance from the
ELECTRICITY supply.When the appliance is not in use for long periods,
disconnect from the electricity supply, empty all
Warning
foods and clean the appliance, leaving the door ajar
This appliance contains hydrocarbons in its to prevent unpleasant smells.
cooling unit maintenance and recharging
must therefore only be carried out by
authorised technicians.
Internal cleaning
Clean the inside and accessories with warm water and
bicarbonate of soda (5ml to 0.5 litre of water). Rinse
and dry thoroughly.
NEVER USE DETERGENTS, ABRASIVE POWDERS,
HIGHLY PERFUMED CLEANING PRODUCTS OR
WAX POLISHES, TO CLEAN THE INTERIOR AS
THESE WILL DAMAGE THE SURFACE AND LEAVE
A STRONG SMELL.
Clean the drain hole of the water trough at regular
intervals and make sure that the drain hole is never
obstructed, so that the defrost water may flow freely.
External cleaning
Wash the outer cabinet with warm soapy water. Do
NOT use abrasive products.
Once or twice a year dust the condenser (black grill)
and the compressor at the back of the appliance, with
a brush or vacuum cleaner, see the figure.
CONDENSER
You MUST ensure that the appliance is switched OFF.DEFROST
TRAY
An accumulation of dust will affect the performance of
COMPRESSOR
the appliance and cause excessive electricity
D662
consumption.
Changing the light bulb
Should the interior light fail to work, first switch off the
appliance and disconnect from the electricity supply,
then replace the bulb as follows:
unscrew the light cover and then pull it outward by
pressing as shown in the figure.
Unscrew the bulb and replace it with a new 15 watt
bulb (available from your nearest Electrolux Service
Centre).
Replace the light cover by sliding it into its original
position and replacing the screw.
D411
8 |
ACEC
