Door reversal
1 Remove screws (A) which secure the top (B) to the
rear brackets.
B
AD
E
F
5. Remove bottom hinge (E) and unscrew part (F)
and reŢt them on the opposite side.
2.Move the top (B) slightly to release it from the6. Unscrew the handle (D). Refit it on the opposite
retainers and remove it.side after having pierced the plugs with a punch.
Cover the holes left open with the plugs contained
in the documentation pack.
Warning!
CIf the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting
of the gasket or accelerate this process by
heating up the part involved with a normal
hairdrier.
3. Unscrew top hinge (C) and reŢt it on the opposite
side.
4. Refit the top (B).
Installation
Take utmost care when handling yourPositioning
appliance so as not to cause any damages to
the cooling unit with consequent possible fluidY Unpack the cabinet and check that it is in good
leakages.condition and free of any transport damage.
Y During normal operation, the condenser andY Place the refrigerator away from direct sunlight and
compressor at the back of the appliance heat upheat sources.
Y The appliance must not be located close to
considerably. Always ensure that there is adequateradiators or gas cookers.
ventilation as a failure to do this will result in
component failure and possible food loss. SeeY Maintain recommended ventilation.
installation instructions.
Y Important: if the supply cord is damaged, it must
be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.
7 |
ACEC
