DESCRIPTION OF THE APPLIANCE
Door reversal directions
1. Disconnect from the electricity supply.
2. Remove all loose items, including food, store3
food in a cool place.
3. Gently lay the fridge/freezer on its back with the
top held away from the floor by 5-8 cm (2-31
inches) of packing;
2
4. Remove the feet (2-3)
MAXmin
ON
AD715 PIED/M
5. Remove bottom hinge (1).
JCOOLCOLDEST FLOW SYSTEMCOLD6. Remove the freezer door by releasing it from the
Bmiddle hinge (H).
7. Unscrew the middle hinge.
I8. Slide out the fridge door from pin (G), unscrewH
the latter and then screw it down into the hinge
provided on the opposite side, after having
C
removed the small plugs which should then be
fitted on the opposite side.
H
9. Refit the fridge door and replace the middle hinge
to the left hand side.
G D
10.Replace the door and bottom hinge (1) on the
opposite side.
F11.Refit the feet (2-3) on the opposite side.
1-3-43-3-3-3-10-10-10-10-
12.Unscrew the handles. Refit them on the opposite
side after having pierced the plugs with a punch.
Cover the holes left open with the plugs
contained in the documentation pack.
EG
Attention
After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdryer on a low setting.
A- Thermostat control for fridge and freezer compartments
B- Dairy compartment
C- Storage shelf
D- Bottle storage shelf
E- Freezing/Storage compartmentsPR228
F- Freezing fresh food compartment
G- Salad drawers
H- Glass shelf
I- Wire shelves
J- Air circulation slider control
Printed on recycled paper
417 |
ACEC
