OPERATION
Door reversal directions
1. Disconnect from the electricity supply.
No damage can be caused by leaving the switch in
2. Remove all loose items, including food, store food inBBefore using
this position for any period of time (see page 11 Low
a cool place.
Remove all securing tapes. Wash inside theambient operation). However should the temperature
3. Gently lay the fridge/freezer on its back with the topappliance with lukewarm water and bicarbonate ofrise above 16!C remember to turn the switch off
held away from the floor by 5-8 cm (2-3 inches) ofagain.A
soda (5 ml to 0.5 litre of water).
packing;
BDo not use soap or detergent as the smell may
4. Remove the feet (B)
linger. Dry thoroughly.
D715
5. Remove bottom hinge (A).
Setting the temperature
6. Remove the freezer door by releasing it from the
middle hinge (H).
The temperature inside the refrigerator is regulated
7. Unscrew the middle hinge.by a thermostat with 6 temperature positions and an
HOOFF� (O) position.
8. Slide out the fridge door from pin (G), unscrew the
latter and then screw it down into the hinge-bladePosition 1 = minimum coldness
provided on the opposite side, after having removedA
Position 6 = maximum coldness
the small plugs (I) which should then be fitted on the
Turn the thermostat dial to the required position.D710
opposite side.
The intermediate position is usually the most
9. Refit the fridge door and replace the middle hinge to
A - Low Ambient Switch
suitable (3-4).
the left hand side.
The thermostat setting can vary as the temperature
10.Replace the door and bottom hinge (A) on the
The freezer compartment
inside the refrigeration compartment depends on the
opposite side.
following factors:
The four-star freezer compartment is suitable for
11.Refit the feet (B) on the opposite side.
� room temperaturestorage of commercially frozen food and for freezing
fresh foods.
� how often the door is opened
� how much food is stored
G
Attention
� position of the applianceFreezing fresh food
After completion of the door reversing operation, check
that the door gasket adheres to the cabinet. If theWhen freezing large amounts of fresh food turn the
Important
ambient temperature is cold (i.e. in Winter), the gasketthermostat to maximum approximately 1 hour prior to
may not fit perfectly to the cabinet. In that case, wait forIf the fridge is not defrosting correctly, it is possiblefreezing.
the natural fitting of the gasket or accelerate thisthat because a very low temperature has beenWhen the food is frozen return to the normal
process by heating up the part involved with a normalselected, the motor is working continuously, whichposition.
hairdryer on a low setting.prevents the defrost cycle from operating.
In any 24 hours you can freeze up to 10 kg.
To ensure correct defrosting, a lower number shouldPlace food to be frozen in the upper drawer of the
be selected on the thermostat and you should notice
freezer as this is the coldest part.
Ithat the motor cuts out from time to time, which is
correct.
Important
If you wish to return to a lower temperature, turn the
thermostat to a higher number, however you shouldIn the event of a power cut do not open the door.
turn the setting lower occasionally to allow automaticThe food in the freezer will not be affected if the
Idefrosting.power cut is short and if the freezer is full. Should
the food begin to thaw, it must be consumed quickly
and must not be re-frozen .
ILow Ambient Temperature Switch
To ensure that the appliance is working efficiently
when the room temperature drops below 16!C, the
switch mounted next to the thermostat control should
be switched on.
165 |
ACEC
