Movable shelves
INSTALLATION
The walls of the refrigerator have runners so that
shelves can be positioned as desired.Important
Warning
For better use of space, the front half-shelves can lie
over the rear ones.IF YOU ARE DISCARDING AN OLD APPLIANCE
It must be possible to disconnect the appliance from
THAT HAS A LOCK OR CATCH ON THE DOOR,
the mains power supply; the plug must therefore be
YOU MUST ENSURE THAT IT IS MADE
easily accessible after installation.
UNUSABLE TO PREVENT YOUNG CHILDREN
BEING TRAPPED INSIDE.
D338Depending upon the position which you choose for
your appliance, you may wish to reverse the way in
which the door opens. To do this, refer to instructions
on ODoor reversal directions�.
Positioning the door shelves
Positioning
To permit storage of food packages of various sizes,
This appliance is designed to operate in ambient
the door shelves can be adjusted in height.
temperatures between 10!C (50!F) and 32!C (90!F).
To do this proceed as shown in the diagram.It should be located in a dry atmosphere, out of
direct sunlight and away from extreme temperature
e.g. not next to a boiler or radiator, or in a very cold
room e.g. an outhouse, where the temperatures may
fall below 10!C (50!F). If these temperatures are
exceeded i.e. colder or warmer, then the appliance
may not operate correctly.100 mm
PR189
You should also ensure that air can circulate freelyAB
around the back and the top of the cabinet. There
must also be at least 100 mm (4�) distance between
the top of the cabinet and any overhanging kitchen10 mm10 mm
furniture (A). Ideally, the appliance should not be
NP007
positioned beneath overhanging furniture (B).
There should also be a gap of 25 mm either side of
the appliance. Do not obstruct the space
underneath. The back of the cabinet may be placed
close to the wall but must not touch it. DO NOT
install in places with restricted ventilation.
Adjust the level of the appliance by screwing out the
adjustable foot, or feet, at the bottom of the cabinet
using your fingers (see figure).
PR219
D200
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted as shown in the figure.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
D594
615 |
ACEC
