K. Frostmatic warning lightFreezing fresh food
TECHNICAL INFORMATION
The section is suitable for freezing fresh
L. Frostmatic function button
food and for long-term conservation of frozen and
To freeze fresh food it is necessary to activate thedeep-frozen food.
Net Fridge Capacity lt.256
Frostmatic function. Press button (L).Warning light (K)For freezing fresh food, activate the Action freeze
lights up.function at least 24 hours in advance.
Net Frezer Capacity lt.82
If you want to interrupt the rapid freezing function, press
Place the food to be frozen in the top section as it is
Energy Consumption kWh/24h0,94button (L) again, otherwise the function switches off
the coldest point.
automatically.Warning light (K) goes out.
Energy Consumption kWh/year343
Conservation of deep-frozen food
Freezing Capacity kg13
Attention!
At the time of startup or after a period out of action,
Rising time h20
When to use the Frostmatic function:place the food in the appliance after having run it for
at least two hours in Action Freeze mode, then take
it out of this mode.
Dimensions mmAbout 6 hoursIntroduction of small quantities of fresh
previouslyfood (around 5 Kg):
High1850
About 24 hoursIntroduction of maximum quantity ofImportant
previouslyfresh food (see serial no. plate):
Width600
In the event of accidental thawing, for example
through interruption to the power supply, if the
Depth625Not requiredIntroduction of frozen food:
length of the period of interruption is higher than
Introduction of small quantities of freshthe value indicated in the technical data table
The technical infomation are situated in the rating plate on the internal left side of the appliance .Not required
food (up to 2 Kg per day):under the heading "recovery period", it will be
necessary to consume the food rapidly or to
cook it immediately and refreeze it (once it has
M. Alarm warning light
cooled down).
INSTALLATION
N. Alarm disarming button
Ice-cube production
LocationAn abnormal rise in the temperature of the freezer
section (e.g. electrical power failure) is indicated byThis appliance is equipped with one or more trays
The appliance should be installed well away from
warning light (M) flashing, and by an audible signal.for the production of ice-cubes. Fill these trays with
sources of heat such as radiators, boilers, direct
When conditions return to normal, the audible signal willwater, then put them in the freezer compartment.
sunlight etc. For safety reasons, minimum ventilation
switch off, while the alarm warning light continues to
must be as shown in Fig.Do not use metallic instruments to remove the
flash.
trays from the freezer.
Appliance positioned under overhanging kitchen wall
If the alarm button (N) is pressed, the indicator (H)
units (see Fig. A).
displays for a few seconds the warmest temperature
Appliance positioned without overhanging kitchen
reached in the section.The audible signal, if sounding,
wall units (see Fig. B).Thawing
will switch off.
Attention: keep ventilation openings clear of
Deep-frozen or frozen food, prior to being used, can
obstruction.
be thawed in the refrigerator compartment or at
Two adjustable feet at the cabinet base allowStartup and temperatureroom temperature, depending on the time available
accurate levelling of the appliance.for this operation.
adjustment
Small pieces may even be cooked still frozen,
directly from the freezer: in this case, cooking will
" Insert the plug in the mains socket. Press button
take longer.
(G).The freezer section is now running.The
Shelf holdersfreezer section is set to a temperature of -18°C.
This temperature will be reached in several
Your appliance is equipped with shelf retainers that
hours.
make it possible to secure the shelves during
transportation." As soon as the freezer is running, the indicator
To remove them proceed as follows:(H) displays the current temperature in the
Move the shelf retainers in the direction of the arrow,freezer, the alarm warning light (M) flashes and
raise the shelf from the rear and push it forward untilthe audible signal is activated.
it is freed and remove the retainers.
" Press the alarm button (N)
" The audible signal switches off, while the alarm
warning light (M) continues to flash until the set
temperature is reached.
5
12 |
ACEC
