CUSTOMER SERVICE ANDt
SPARE PARTS
If the appliance is not functioning properlyT, check that:o obtain fast service, it is essential that when
the plug is firmly in the wall socket and the mainsyou apply for it you specify the model and serial
power switch is on;number of your appliance which can be found on
the guarantee certificate or on the rating plate
there is an electricity supply (find out by plugging inlocated inside the appliance, on the bottom left-
another appliance);hand side.
the thermostat knob is in the correct position.
If there are water drops on the bottom of the cabinet,
check that the defrost water drain opening is not
obstructed (see "Defrosting" section).
If your appliance is still not working properly after
making the above checks, contact the nearest service
centre.
TECHNICAL SPECIFICATIONS
The technical data is indicated in the rating plate on the left side inside the appliance.
INSTALLATION
lf this appliance featuring magnetic door seals isFor operation with different voltages, a suitably sized
to replace an older appliance having a spring lockauto-transformer must be used.
(latch) on the door or lid, be sure to make thatImportant
spring lock unusable before you discard the oldThe appliance must be earthed.
appliance. This will prevent it from becoming a
death-trap for a child.The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not
Positioningearthed. connect the appliance to a separate
earth in compliance with current regulations,
The appliance should be installed well away from
sources of heat such as radiators, boilers, directconsulting a specialist technician.
sunlight etc.The Manufacturer declines all responsibility if the
Best performance is obtained with ambientabove safety precautions are not observed.
temperature between +18!C and +43!C (class T);Attention!
+18!C and +38!C (class ST); +16!C and +32!CIt mustbe possible to disconnect the appliance
(class N); +10!C and +32!C (class SN).from the mains power supply; the plug must
The class of your appliance is shown on its rating
plate.therefore be easily accessible after installation.
This appliance complies with EEC directive
For building-in and door reversibility refer to thenumber, 87/308 of 2/6/87 relative to radio
relevant instructions.interference suppression.
This appliance complies with the following
Electrical connectionE.E.C. Directives:
- 73/23 EECof 19.2.73 (Low Voltage Directive) and
Before plugging in, ensure that the voltage and
subsequent modifications;frequency shown on the serial number plate
- 89/336 EECof 3.5.89 (Electromagneticcorrespond to your domestic power supply.
Compatibility Directive) and subsequentVoltage can vary by ?6% of the rated voltage.
modifications.
17 |
ACEC
