Door reversal
1. Remove bottom hinge (5).
2. Remove door (4).
3. Unscrew pin (2) from the top hinge (1) and reŢt it
on the opposite side.
4. Unscrew part (6) and reŢt it on the opposite side.
5. ReŢt the door and the bottom hinge on the
opposite side.
6. Unscrew the handle (3) and refit it on the opposite
side. Cover the holes left open with the plugs
contained in the documentation pack.
Warning!
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting
of the gasket or accelerate this process by
heating up the part involved with a normal
hairdrier.
Installation
Take utmost care when handling yourThe climate classification can be found on the rating
appliance so as not to cause any damages toplate, which is located inside the cabinet on the left
the cooling unit with consequent possible fluidhand wall.
leakages.The following table shows which ambient
Y During normal operation, the condenser andtemperature is correct for each climate classification:
compressor at the back of the appliance heat upClimate
considerably. Always ensure that there is adequateclassificationfor an ambient temperature of
ventilation as a failure to do this will result in
component failure and possible food loss. SeeSN+10 to +32!C
installation instructions.
Y Important: if the supply cord is damaged, it mustN+16 to +32!C
be replaced by a special cord or assembly availa-ST+18 to +38!C
ble from the manufacturer or its service agent.
T+18 to +43!C
Positioning
Y Unpack the cabinet and check that it is in good
condition and free of any transport damage.
Y The appliance must not be located close to
radiators or gas cookers.
Y Avoid prolonged exposure of the appliance to
direct sunlight.
Y Maintain recommended ventilation.
Y For safety reasons, minimum ventilation must be100 mm
as shown in Fig.:
Appliance positioned under overhanging kitchenAB
wall units (see Fig.-A).
Appliance positioned without overhanging kitchen
units (see Fig.-B).
Y Two adjustable feet at the cabinet base allow10 mm10 mm
accurate levelling of the appliance.NP008
15 |
ACEC
