COOL , HEAT, and FAN ONLY Operation1TEMP Button : Push the TEMP button to decrease the indoor
1. If the AUTO mode is not comfortable , you may manually overridetemperature setting or to adjust the TIMER in a counter-clockwise
direction.
the settings by using COOL, DRY, HEAT( HEAT PUMP units only),
or FAN ONLY modes.2MODE Select Button: Each time you push the button, a mode is
2. Push the TEMP button to set the desired room temperature. selected in a sequence that goes from AUTO COOL DRY
When in COOLING mode, the most comfortable settings are 21 CHEAT and FAN as the following figure indicates:
or above. When in HEATING mode, the most comfortable settings AUTOCOOLDRYHEATFAN
are 28 C or b elow.
3. Push the FAN SPEED to select the FAN mode of AUTO, HIGH,NOTE: HEAT only for Heat Pump
MED or LOW.
3SWING Button: Push this switch button to change the louver
4. Push the ON/OFF button. The operation lamp lights and the airangle .
conditioner starts to operate per your settings. Push the ON/OFF
button again to stop this unit operation.4RESET Button: When the RESET button is pushed, all of the current
settings are cancelled and the control will return to the initial settings.
NOTE5ECONOMIC RUNNING Button: Push this button to go into the
The FAN ONLY mode cannot be used to control the temperature. WhileEnergy-Saving operation mode.
in this mode, only steps 1 3 and 4 may be performed.6LOCK Button: Push this button to lock in all the current settings. To
DRY OPERATIONrelease settings, push again.
1. Push the MODE button to select DRY.7CANCEL Button: Push this button to cancel the TIMER settings.
2. Push the TEMP button to set the desired temperature from
21 C to 2 8 C.8TIMER Button: This button is used to preset the time ON (start
3. Push the ON/OFF button. The operation lamp lights and the airto operate) and the time OFF (turn off the operation).
conditioner starts to operate in the DRY mode. Push the ON/OFF9ON/OFF Button: Push this button to start the unit operation. Push
button again to stop this unit operation.the button again to stop the unit operation.
NOTE10FAN SPEED Button: This button is used for setting Fan Speed in
Due to the difference of the set temperature of the unit and the the sequence that goes from AUTO LOW MED to HIGH, then
actual indoor temperature, the Air Conditioner when in DRY modeback to Auto.
will automatically operate many times without running the COOL
and FAN mode.11TEMP Button : Push the button to increase the indoor temperature
setting or to adjust the TIMER in a clockwise direction.
TIMER OPERATION
12VENT Button : Push this button to set the ventilating mode. The
PUSH TIMER button to set the on and off times of the unit. ventilating mode will operate in the following sequence :
1. To set the STARTING time.
1.1 Please push the CANCEL button to cancel any former settings.ContinuousAutoOff
1.2 Push the TIMER button. The remote controller will show the
TIMER and the signal "h" is shown on the display panel. The Ventilation Function is available for the Fresh Star Series.
control is now ready to reset the TIMER ON to start the operation.
1.3 Push the TEMP button ( or ) to set desired unit START
time .
1.4 After setting the TIMER there will be a one-half second delay
before the remote controller transmits the signal to the Air
Conditioner. Then, after approximately another 2 seconds ,the
set temperature will re-appear on the digital display.
52 |
ACEC
