Filling with saltRinse aid
Rinse aid is automatically added during the last rinse, ensuring
Only use salt specifically designed for use in
thorough rinsing, and spot and streak free drying.
dishwashers.
All other types of salt not specifically designed for use inRinse aid is automatically added during the last rinse, ensuring
a dishwasher, especially table salt, will damage the waterthorough rinsing, and spot and streak free drying.
softener.
The dispenser, which is positioned inside the door, holds about
Only fill with salt just before starting one of the complete
110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing
washing programmes.
programmes, depending upon the dosage setting.
This will prevent any grains of salt or salty water, which
may have been spilt, remaining on the bottom of the
machine for any period of time, which may cause
corrosion.Filling with rinse aid
1.Open the container by turning the lid (A) anticlockwise.
To fill:
2.Fill with rinse aid exactly up to the level indicator marked
1.Open the door, remove the lower basket and unscrew the "max".
cap of the salt container by turning it anticlockwise.
2.Pour 1 litre of water inside the container (this is necessary
only before filling with salt for the first time).
3.Using the funnel provided,
pour in the salt until the
container is full.SALE
ZOUT
SALT
4.Replace the cap making SALZ
SEL
sure that there is no trace
of salt on the screw thread BR01BR13
or on the gasket.
Ensure that the lid is closed after every refill.
5.Screw on the cap tightly
turning it clockwise.
SR14
Adjusting the dose
The salt container will require topping up periodicallyAccording to the finish and drying results obtained, adjust the. You are
reminded of this by the salt indicator light on the control paneldose of rinse aid by means of the 6 position selector (C)
which comes on when the salt has finished.(position 1 minimum dosage, position 6 maximum dosage).
The salt indicator light on the control panel can remainIncrease the dose if there are drops of water or lime spots on
illuminated for 2-6 hours after the salt has beenthe dishes after washing.
replenished, assuming the dishwasher remains switched
Reduce it if there are sticky
on. If you are using salts that take longer to dissolve then
whitish streaks on the
this can take longer. The function of the machine is not
dishes.
affected.
Do not worry if water over flows from the unit when filling with
salt, this is quite normal.
BR02
Clean up any rinse aid spilt during filling with an
absorbent cloth to avoid excess foaming during the next
wash.
Use only branded rinse aid for dishwashers. Never fill the
rinse aid dispenser with any other substances (e.g.
dishwasher cleaning agent, liquid detergent). This would
damage the appliance.
8 |
ACEC
