Filling with dishwasher salt - ONLYRinse aid
required ih hard water areasRinse aid is automatically added during the last rinse, ensuring
Only use salt specifically designed for use inthorough rinsing, and spot and streak free drying.
The dispenser, which is positioned inside the door, holds about
dishwashers.110 ml of rinse aid, which is sufficient for between 16 and 40
All other types of salt not specifically designed for use indishwashing cycles, depending upon the dosage setting.
a dishwasher, especially table salt, will damage the water
softener.
Only fill with salt just before starting one of the complete
washing programmes. Filling with rinse aid
This will prevent any grains of salt or salty water, which
may have been spilt, remaining on the bottom of the1.Open the container by pressing the release button (A).
machine for any period of time, which may cause2.Add the rinse aid until the container is completely full. The
corrosion.maximum level for filling is indicated by "max".
To fill:
1.Open the door, remove the lower basket and unscrew the
cap of the salt container by turning it anticlockwise.
2.Pour 1 litre of water inside the container (this is necessary
only before filling with salt for the first time).
3.Using the funnel provided,
pour in the salt until the
container is full.
4.Replace the cap making Ensure that the lid is closed after every refill.
sure that there is no trace
of salt on the screw Clean up any rinse aid spilt during filling with an
thread or on the gasket.absorbent cloth to avoid excess foaming during the next
wash.
5.Replace the cap tightly
turning it clockwise until it Only use branded rinse aid for dishwashers. Never fill the
stops with a click.rinse aid dispenser with any other substances (e.g.
dishwasher cleaning agent, liquid detergent). This would
damage the appliance.
The salt container will require topping up periodically. You are
reminded of this by the salt indicator light on the control panel
which comes on when the salt has finished.Adjusting the dose
The salt indicator light on the control panel can remainAccording to the finish and drying results obtained, adjust the
illuminated for 2-6 hours after the salt has beendose of rinse aid by means of the 6 position selector (position
replenished, assuming the dishwasher remains switched1 minimum dosage, position 6 maximum dosage).
on. If you are using salts that take longer to dissolve thenThe dose is factory set in
this can take longer. The function of the machine is notposition 4.
affected.Increase the dose if there are
drops of water or lime spots
Do not worry if water overflows from the unit when filling withon the dishes after washing.
salt, this is quite normal.
Reduce it if there are sticky
whitish streaks on the dishes
or a bluish film on glassware
or knife blades.
Top up the rinse aid when the indicator light on the control
panel illuminates.
7 |
ACEC
