Something not working
Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions
given here, without calling out an engineer.
Important:If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or installation a charge will
be made, even if the appliance is in guarantee.
...a flashing fault code appears
The dishwasher will not start or stops during operation.
The intervention of an alarm is indicated by:
- continuous flashing of the start/cancel indicator light,
- a combination of flashing and pauses of the end of cycle indicator light (as described in the chart).
Open the door and carry out the following suggested corrective actions.
Fault code / malfunctionPossible causeSolutions
- continuous flashing of the The water tap is blocked or furred withClean the water tap.
"start/cancel" indicator lightlimescale.
- 1 flash of the "end of cycle" The water tap is turned off.Turn the water tap on.
indicator light
The filter (where present) in the threaded hoseClean the filter in the threaded hose
fitting at the water inlet valve is blocked.fitting.
The machine does not fill with
water.The water inlet hose has not been correctly laidCheck the water inlet hose connection.
or it is bent or squashed.
- continuous flashing of the The sink spigot is blocked.Clean out the sink spigot.
"start/cancel" indicator light
- 2 flashes of the "end of cycle" The water drain hose has not been correctly laidCheck the water drain hose connection.
indicator lightor it is bent or squashed.
The dishwasher will not drain.
- continuous flashing of the Anti-flood device is activated.Close the water tap and contact the
"start/cancel" indicator lightService Force Centre.
- 3 flashes of the "end of cycle"
indicator light
Once these checks have been carried out; close the door and press the start/cancel button. The programme will continue from the
point at which it was interrupted. If the fault code reappears contact the Service Force Centre.
For other combinations of fault codes not described in the above chart, please contact your Service Force Centre.
...there are problems when operating the dishwasher
MalfunctionPossible causeSolutions
The dishwasher door has not been properlyClose the door.
closed.
The main plug is not plugged in.Insert the mains plug.
The programme does not start
The fuse has blown in the household fuse box.Replace the fuse.
For dishwasher models with delay startIf dishes are to be washed immediately,
option:cancel the delay start.
Delay start has been selected.
There is a whistling noise duringThe whistling is not a cause for concern.Use a different brand of detergent.
washing
15 |
ACEC
