Start the wash programme
1. Check that when the dishes and cutlery areUsing the pause function the dishwasher can be tem-
loaded in the dishwasher the spray arms are freeporarily stopped.
to rotate.1. Press the On/Off button. The wash programme
2. Open the tap fully.will stop.
3. Shut the door.2. All indicators will go out.
4. Press the On/Off button. The On/Off button indica-3. When after a short time the wash programme is to
tor lights up.continue, press the On/Off button again. The wash
5. Press the programme button for the required pro-programme will continue.
gramme (see ?Programme Table?). The pro-
The wash programme should not be stopped
gramme indicator lights up. One or two lights will2 for a prolonged period or the cooled water
flash in the multidisplay. During this time it is pos-will need to be reheated resulting in
sible to reselect the programme. The selected
increased energy consumption.
wash programme will start after about 6 seconds.
The current wash programme stage will always be
shown in the multidisplay.
Load Sensing
If the top light and/or the middle light in theIf a wash programme is started even though there are
3 multidisplay flash after the programme hasonly a few dishes in the upper and/or lower basket, an
started please read the section ?What to dointelligent electronic system adjusts the amount of
if...?.water and the duration of the wash programme to the
number of dishes. By this means it is possible to
Interrupting or ending the wash wash only a few dishes quickly and economically. At
programmehalf load (6 place settings), up to 2 litres of water and
0.2 kWh of electricity are saved.
Only interrupt a wash programme that is run-
3
ning if it is absolutely necessary. After the
appliance has been closed again the air that
has entered will be greatly heated andSwitching Off the Dish-
expand. As a result water may penetrate the
base of the appliance and trigger the anti-washer
flood system.
Switch off the dishwasher when w is illuminated on
the programme progress display.
Interrupt the wash programme by open-
1. Press the ON/OFF button M. The ON/OFF but-
ing the door.
ton M indicator extinguishes.
Hot steam can escape from the appliance
1 when the door is opened. (deleted by theHot steam may escape from the appliance
1
reviewer) Open the door carefully.when opening the door immediately after the
end of the programme. Therefore:
1. Open the door of the dishwasher. The wash pro-
2. Open the door carefully.
gramme will stop.
2. Lights are flashing in the multidisplay.
3. Shut the door. The wash programme continues.
Emptying the Dishwasher
3
Ending the wash programme
1. Press the button for the wash programme that is Hot dishes are sensitive to knocks. The dishes
running and hold it down until the programme indi-should therefore be allowed to cool down before
cator for the wash programme goes out.removing them from the appliance.
2. Release the programme button; the wash pro- Leave the dishes in the dishwasher for approx.
gramme has been ended.15 minutes after the end of the programme so that
they dry better and can cool down.
Pause function First empty the lower basket, and then the upper
rack. By using this procedure you will avoid any
The pause function can only be initiated
3 water that may be remaining in the upper basket,
before the drying section of the programme.dripping onto the dishes in the lower basket and
If the pause function is initiated during the
leaving water marks.
drying section of the programme the wash
programme is ended.
20 |
ACEC
