INSTALLATION
LocationATTENTION!
It must be possible to disconnect the appliance fromThe appliance should be installed well away from
the mains power supply; the plug must therefore besources of heat such as radiators, boilers, direct
easily accessible after installation.sunlight etc.
Electrical connectionDoor reversibility
The applianceOs door have been locked in position
for transport by means of pins on both sides.Before plugging in, ensure that the voltage and
According to the door opening direction, removefrequency shown on the serial number plate
relevant pins at the top and at the bottom.correspond to your domestic power supply. Voltage
can vary by ?6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the following
E.E.C. Directives:
- 87/308 EEC of 2/6/87 relative to radio interference
suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
19 |
ACEC
