13294920.qxd 30/11/2005 11:22 Pagina 28 (Nero/Process Black pellicola)
Building-inThe height (C-Fig. C) depends on the height of the
adjacent furniture's base.
This appliance has been designed to be built into the
!42 !52"
kitchen furniture.
The recess should have the dimensions shown in picture
A.
!2!! !1-
213!0
2
020"2
!"22 !
0
2
b) Hinges
2!"
To mount the hinges it is necessary to drill two holes
(dia. 35 mm, depth 12.5-14 mm depending on the depth
When installing the appliance into the kitchen furniture
of door furniture) on the inner side of the door. The
ensure, if possible, the hoses are placed in either of the
distance between the holes hobs fixing centres must be
two recesses on the back of the appliance. This will help
416 mm.
to prevent the hoses from becoming kinked or trapped.
The distance (B) from upper edge of the door to the
Picture AB.
centre of the hole depends on the adjacent furniture's
dimensions.
The required dimensions are given in the picture C.
The hinges will be fixed to the door by means of screws
for wood (2-Fig. B) supplied with the appliance.
c) Mounting the door
Fix the hinges (1) to the machine by means of the
M5x15 screws (3-Fig. B). The hinges can be adjusted to
compensate for possible uneven thickness of the door.
To align the door perfectly it is necessary to loosen the
Preparation and assembly of the doorscrew (3-Fig. B), adjust the door and tighten the screw
The machine is originally pre-arranged for the assemblyagain.
of a door opening from right to left.
d) Counter-magnet (6)
In this case it is sufficient to screw in the hinges (1) and
the counter-magnet (6) provided with the appliance, atThe appliance is pre-arranged for a magnetic closure of
the right level (Fig. B).the door. To enable a correct operation of this device, it
is necessary to screw the counter-magnet (6) (steel disk
+ rubber ring) into the inner side of the door.
Its position must correspond to the magnet (4) on the
appliance (see picture D).
a) Door
The dimensions of the door should be:
- width595-598 mm
- thickness 16-22 mm
28 |
ACEC
