Installation
UnpackingPositioning
Install the machine on a flat hard floor.
All transit bolts and packing must be removed
Make sure that air circulation around the machine is
before using the appliance.
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
You are advised to keep all transit devices so that
units.
they can be refitted if the machine ever has to be
Carefully level by screwing the adjustable feet in or
transported again.
out. Never place cardboard, wood or similar
1. Using a spanner, unscrew and remove the rear
materials under the machine to compensate for any
right-hand bolt and lay the machine on its back,
unevenness in the floor.ENGLISH
taking care not to squash the hoses. This can be
avoided by placing one of the corner packing
pieces between the machine and the floor.
P1051
P0255
Water inlet
2. Remove the polystyrene block from the bottom of
Connect the water inlet hose to a tap with a 3/4"
the machine and release the two plastic bags.
thread.
3. Carefully remove the right-hand bag (1) then the
The other end of the inlet hose which connects to the
left-hand bag (2) by pulling them towards the
machine can be turned in any direction. Simply
centre of the machine.
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks.
2
1
P1068P1066
P1088
4. Set the machine upright and remove the two P0021
remaining bolts from the back.
The inlet hose must not be lengthened. If it is too
5. Pull out the three plastic spacers from the holesshort and you do not wish to move the tap, you will
into which the bolts were fitted.have to purchase a new, longer hose specially
6. Plug the open holes with the plugs which you willdesigned for this type of use.
find at the back of the appliance.
P0256P0020
27 |