132978020.qxd 25/09/2006 14.40 Pagina 21 (Nero/Process Black pellicola)
Unscrew and remove the filter.The dangers of freezing
Clean carefully under a fast running tap.If the machine is exposed to temperatures below 0°C,
certain precautions should be taken.
ITurn off the water tap.
IUnscrew the inlet hose.
IUnhook the drain hose from the rear support and
position the end of this hose and that of the inlet
hose in a bowl. Run the draining programme.
IDisconnect the appliance.
IScrew the inlet hose and reposition the drain hose.
IWhen you intend to start the machine up again,
Warningmake sure that the room temperature is above 0°C.
When the appliance is in use and depending on the
Emergency emptying out
programme selected there can be hot water in the filter.
Never remove the filter during a wash cycle, alwaysIf the water is not discharged, proceed as follows to
wait until the appliance has finished the cycle, and is
empty out the machine:
empty. When replacing the filter, ensure it is securely
Ipull out the plug from the power socket;
retightened so as to stop leaks and young children being
Iclose the water tap;
able to remove it.
Iif necessary, wait until the water has cooled down;
I
The water inlet filterUnscrew and remove the filter;
Iplace a bowl on the floor. The water should drain by
If your water is very hard or contains traces of lime
gravity into the bowl. When the bowl is full, empty
deposit, the water inlet filter may become clogged.
the bowl. Repeat the procedure until water stops
It is therefore a good idea to clean it from time to time.
flowing out;
Turn off the water tap. Unscrew the water inlet hose.
Iclean the filter if necessary as previously described;
Clean the filter using a hard bristle brush.
Iscrew the filter again.
Tighten up the inlet hose.
21 |