132992990-EWF1000?GB 16/07/03 09:12 Pagina 8
The other end of the inlet hose which connects toAny extension applied to the drainage hose should
the machine can be turned in any direction. Simplynot be longer than 200 cm and its diameter must not
loosen the fitting, rotate the hose and retighten thebe smaller than that of the original hose. Use a
fitting, making sure there are no water leaks.suitable fitting for the connection.
P0021
P1118
The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you willThe drain hose must not be kinked.
have to purchase a new, longer hose speciallyFor a correct functioning of the machine the
designed for this type of use.drain hose must remain hooked on the proper
Important!support piece situated on the top part of the
Before connecting up the machine to new pipeworkback side of the appliance.
or to pipework that has not been used for some
time, run off a reasonable amount of water to flush
Electrical connection
out any debris that may have collected in the pipes.
This machine is designed to operate on a 220-230
V, single-phase, 50 Hz supply.
Water drainageCheck that your domestic electrical installation can
The end of the drain hose can be positioned in threetake the maximum load required (2.2 kW), also
ways:taking into account any other appliances in use.
Hooked over the edge of a sink using the plasticConnect the machine to an earthed socket.
hose guide supplied with the machine. In this
case, make sure the end cannot come unhookedThe manufacturer declines any responsibility
when the machine is emptying.
This could be done by tying it to the tap with a piecefor damage or injury through failure to comply
with the above safety precaution.
of string or attaching it to the wall.Should the appliance power supply cable
need to be replaced, this should be carried
out by our Service Centre.
Please ensure that when the appliance is
installed the power supply cable is easily
accessible.
P0022
In a sink drain pipe branch. This branch must be
above the trap so that the bend is at least 60 cm
above the ground.
Directly into a drain pipe at a height of not less
than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain pipe
must be larger than the outside diameter of the drain
hose.
8 |
ACEC
