132991140 gb.qxd 21/08/2003 10:09 Pagina 6 (Nero/Process Black pellicola)
The other end of the inlet hose which connects toThe drain hose must not be kinked.
the machine can be turned in any direction. Simply
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks
For a correct functioning of the machine the
drain hose must remain hooked on the proper
support piece situated on the top part of the
The inlet hose must not be lengthened. If it is tooback side of the appliance.
short and you do not wish to move the tap, you will
have to purchase a new, longer hose specially
Electrical connection
designed for this type of use.This machine is designed to operate on a 220-230
V, single-phase, 50 Hz supply.
Water drainageCheck that your domestic electrical installation can
The end of the drain hose can be positioned in threetake the maximum load required (2.2 kW), also
taking into account any other appliances in use.
ways:Connect the machine to an earthed socket.
Hooked over the edge of a sink using the plastic
hose guide supplied with the machine. In this
case, make sure the end cannot come unhookedThe manufacturer declines any responsibility
when the machine is emptying.for damage or injury through failure to comply
This could be done by tying it to the tap with a piecewith the above safety precaution.
of string or attaching it to the wall.Should the appliance power supply cable
need to be replaced, this should be carried
out by our Service Centre.
Please ensure that when the appliance is
installed the power supply cable is easily
accessible.
In a sink drain pipe branch. This branch must be
above the trap so that the bend is at least 60 cm
above the ground.
Directly into a drain pipe at a height of not less
than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain pipe
must be larger than the outside diameter of the drain
hose.
6 |
ACEC
