132979070gb.qxd 31/07/2006 9.35 Pagina 35
installation electrolux 35
3. Set the hose correctly by looseningIn a sink drain pipe branch. This
the ring nut. branch must be above the trap so that
After positioning the inlet hose, bethe bend is at least 60 cm above the
sure to tighten the ring nut again toground.
prevent leaks.Directly into a drain pipe at a
4. Connect the hose to a tap with a 3/4?height of not less than 60 cm and not
thread. Always use the hose suppliedmore than 90 cm. The end of the drain
with the appliance. hose must always be ventilated, i.e.
the inside diameter of the drain pipe
must be larger than the outside diameter
of the drain hose.
The drain hose must not be kinked.
The inlet hose must not be lengthened. If
it is too short and you do not wish to
move the tap, you will have to purchaseThe drain hose may be extended to a
maximum of 4 metres. An additional
a new, longer hose specially designed
for this type of use.drain hose and joining piece is available
from your local Service Centre.
Water drainage
Electrical connection
The end of the drain hose can be
positioned in three ways:This machine is designed to operate on
a 220-230 V, single-phase, 50 Hz
Hooked over the edge of a sinksupply.
using the plastic hose guide
supplied with the machine. In thisCheck that your domestic electrical
case, make sure the end cannot comeinstallation can take the maximum load
required (2.2 kW), also taking into
unhooked when the machine is
emptying. This could be done by tying itaccount any other appliances in use.
to the tap with a piece of string orConnect the machine to an earthed
attaching it to the wall.socket.
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the above
safety precaution. Should the appliance
power supply cable need to be
replaced, this should be carried out by
our Service Centre.
Please ensure that when the appliance is
installed the power supply cable is easily
accessible. |
ACEC
