new_12108_14108.qxp 12/13/2005 10:52 AM Page 25
5. Set the machine upright and remove the remainingUnpacking
rear screw. Slide out the relevant pin.
All transit bolts and packing must be 6. Plug all the holes with the plugs which you will
find in the envelope containing the instructionremoved before using the appliance.
manual.
You are advised to keep all transit devices so that they
can be refitted if the machine ever has to be transported
again.
1. Using a spanner, unscrew and remove the two
rear bottom screws. Slide out the two plastic pins.
Lay the machine on its back, taking care not to
squash the hoses. This can be avoided by placing
one of the corner packing pieces between the
machine and the floor
Important !
You are advised to keep all the packaging for re-use
in case the machine is to be transported again.
In case of moving out the same precautions as per
paragraph The dangers of freezing must be taken
i.e. the residual water in the hoses must be pumped
out.
Positioning
Install the machine on a flat hard floor.2. Remove the polystyrene block(s) from the bottom
Make sure that air circulation around the machine is
of the machine and release the two plastic bags.
not impeded by carpets, rugs etc. Check that the3. Very carefully slide out the left polythene bag,
removing it towards the right and thenmachine does not touch the wall or other kitchen
units.
Never place cardboard, wood or similar materials
under the machine to compensate for any
unevenness in the floor.
Your new washing machine has been designed to be
permanently plumbed in to your homes water supply
and drainage system. However, if this is not possible,
it may be connected to suitable existing tap with the
drain hose discharging into a sink.
The appliance has one inlet hose, with female 3/4downwards.
4. Very carefully slide out the right polythene bag,
BSP thread connector. If this connection is notremoving it towards the left and then upwards.
compatible with the plumbing of the existingRemove the bottom cover found inside the drum
of your appliance, lay its hook as the arrow Ainstallation, a variety of connectors are available from
indicates and push the top of the cover to seal itgood hardware stores and plumbers merchants to
closedsuit most domestic plumbing. Any alteration to your
existing plumbing must be carried out by a
competent person, or qualified plumber.
Installation on a Suspended Floor
Suspended wooden floors are particularly
susceptible to vibration. To help prevent vibration we
recommend you place a waterproof wood panel, at
least 15 mm thick under the appliance, secured to at
least 2 floor beams with screws. If possible install the
Important: You can find more detailed instructionsappliance in one of the corners of the room, where
regarding the bottom cover assembling in its relativethe floor is more stable.
bag.
25 |
ACEC
