Part 1 - INSTALLATION INSTRUCTIONS
3.5 - The hood must be positioned at least 65 cm above a cooking appliance.
3.6 - Never do flambé cooking under this cooker hood.
3.7 - Never leave frying pans unattended during use as overheated fats and oils may
catch fire.
3.8 - Before carring out any kind of maintenance or cleaning, disconnect the hood from
the mains supply.
3.9 - If the room where the cooker hood is to be used contains a fuel burning appliance
such as a central heating boiler, ensure that there is an adequate supply of air into
the room. When the cooker hood is used in conjunction with other appliances
supplied with energy other than electric, the negative pressure in the room must not
exceed 0,04 mbar to prevent fumes being drawn back into the room by the cooker
hood.
4 - Installation
To install the hood proceed by fitting the components in the following order:
4.1 - Fitting of upper telescopic frame TS
4.2 - Fitting of lower telescopic frame TI
4.3 - Setting the hood for recirculation or evacuation
4.4 - Connection to the mains supply
4.5 - Fitting the chimney
4.6 - Fitting the canopy
4.7 - Electrical connection of controls and functional test
4.1 - Fitting of upper telescopic frame TS
The frame is suitable for fixing to the ceiling as illustrated in (2A) or to a wooden
buttress (2B) of adequate thickness and well secured to the ceiling or other
carrying structure. Remember that the recycled air can be directed in four different
directions: such choice must be made when securing the upper frame (see point
d ).
a) Separate the lower frame TI (6C) from the upper part 6A by loosening the four
retaining screws 6B with the socket head screw wrench provided 6D .
b) Remove the screws 3A and pull out the upper pipe S (3B) of the telescopic
chimney.
c) Using a plumb line or similar tool, mark the centre on the ceiling or buttress from
the centre of the cooking appliance.
d) (fig. 5) Use the drilling template 5A provided to mark the centre on the ceiling or
wooden buttress and align one of the two axes (A or B) of the template parallel
with the long side of the hob 5C bearing in mind in which direction you want the
filtered air to exit. Vent direction 1 or 2, as indicated on the template, is determined
during the subsequent fitting phase of the lower frame (paragr. 4.2). Mark the
position of the 4 holes on the template, plus the power cable hole.
e) Position 5E indicates the useful area to pass the mains cable.
11 |
ACEC
