ENGLISH
EC DECLARATION OF CONFORMITY
GBEC DECLARATION OF CONFORMITY
Electrolux Motor AS,N-1708 Sarpsborg, Norway hereby declares that the following chain saws:
Husqvarna 315 Electric and Husqvarna 318 Electric, with serial numbers starting at 20100000,
-are manufactured in compliance with EU Machine Directive 98/37/EC,
EU directive 73/23/EEA (Low Voltage Directive), 89/336/EEC (Electromagnetic Compatibility),
and 2000/14/EC (Noise Emission in the environment by equipment for use outdoors)
- are manufactured in compliance with the following harmonized standards: EN 292-1-2, prEN 50144-2-13:96,
HD 400.3 L S2, EN 55014-1:97, EN 55014-2:97, EN 61000-3-2:95 and EN 61000-3-3:95
Notified body 0404 SMP Svensk Maskinpršvning AB, Fyrisborgsgatan 3, SE-754 50 Uppsala, Sweden, has:
- performed the type examination required by the third indent of Article 8(2)(c)
- issued EC type examination certificate No404/99/686 - Husqv.arna 315 Electric and
404/99/687 - Husqvarna 318 Electricpursuant to Directive 98/37/EC, Annex VI (4)
The chain saw submitted is identical to the samples submitted for EU type examination.
The measured and guaranteed sound power levels in accordance with Directive 2000/14/EC are set forth
under Technical Data in the UserOs Manual.
Sarpsborg, 1 December 2001.
Jan Hansen, President
IMPORTANT! BEFORE USING CHAIN SAW
CAUTION!
The chain saw must not be modified in any way under any circumstances without
the permission of the manufacturer. Use only original accessories. Unauthorized
modifications and/or accessories may cause serious or fatal injury of the operator
or others.
Y Read operating instructions carefully.
IMPORTANT!
YAlways observe the �Safe UseE recommendations on page 6.
Y Check chain and guide bar for correct assembly and adjustment.
min. 1 mm
max.maks. 30 m
YStart the saw.
Do not use a coiled
power cable!
YDo not start sawing until an adequate amount of oil has
reached the chain.
Minimum
2
wire cross-section: 1 mm
Y Incorrect chain tensioning increases wear on chain, sprocket
and guide bar, and may result in damage to these partsMaxim.um
cable length: 30 m
YImproper use of power cable may lead to serious motor damage.
Voltage: 230 V
5 |
ACEC
