STORAGE
To ready the machine for storage, follow these
Winter storage
steps:
At the end of the season, the machine should
1. Clean the machine carefully, particularly the
be readied for storage (or if it will not be in use
chassis and working equipment. Mend damage
for longer than 30 days). Fuel allowed to stand
to the paint to prevent rust.
for long periods of time (30 days or more) can
leave sticky residues that can plug the2. Inspect the machine for worn or damaged parts
carburetor and disrupt engine function.
and tighten any nuts or bolts that may have
become loose.Fuel stabilizers are an acceptable option to
reducing sticky residues during storage. If3. Change the engine oil; dispose of properly.
alkylate gasoline (Aspen) is used, stabilizers
4. Open the fuel valve. Empty the fuel tank (1) and
are unnecessary because this fuel is stable.
the carburetor (2).
However, you should avoid switching between
regular and alkylate gasoline as sensitive
rubber components can harden. Add stabilizer
to the fuel in the tank or in the storage
container. Always use the mixing ratios
specified by the manufacturer of the stabilizer.
Run the engine for at least 10 minutes after
adding the stabilizer so that it reaches the
carburetor. Do not empty the fuel tank and the
carburetor if you have added stabilizer.
8011-048
5. Close the fuel valve.
WARNING!
6. Remove the spark plug and pour about a
Never store an engine with fuel in the
tablespoon of engine oil in the cylinder. Turn
tank indoors or in poorly ventilated
over the engine so that the oil is evenly
spaces where fuel vapor can come in
distributed and then refit the spark plug.
contact with open flame, sparks or a
Put the engine in the compression phase where
pilot light such as in a boiler, hot water
the triangle mark on the sleeve of the starter is
tank, clothing drier, etc.
aligned with the upper hole in the starter.
Handle the fuel with caution. It is veryNote: Compression phase occurs every second
flammable and careless use can causerevolution.
serious damage to person and
property. Drain the fuel into an
approved container outdoors and far
away from open flame. Never use
gasoline for cleaning. Use a degreaser
and warm water instead.
Service
When ordering spare parts, please specify the8011-049
purchase year, model, type, and serial number.
7. Lubricate all grease nipples, joints and shafts
Always use genuine Husqvarna spare parts.
as described in the chapter ?Lubrication/
An annual check-up at an authorized serviceLubrication schedule?.
workshop is a good way to ensure that your
8. Store the machine in a clean, dry place and
machine performs its best the following season.
cover it for extra protection.
38 |
ACEC
