Troubleshooting
If there is no picture or the TV does not operate normally, make sure the problem isnOt due to
the reasons indicated below.
If the problem persists even after taking the measures indicated, please contact a service
technician.
Cannot turn the TV onPoor picture
Y Press the Main power button on the TV.Y Press the COLOUR SYSTEM button to select an-
other colour system. (see page 8.)
Y Connect the power cord to the AC outlet.
Y Adjust the picture settings. (see page 14.)
Y Is a component signal output device, such as a
The screen turns blue
DVD player, connected correctly? (see page 5.)
Y Is the BLUE BACK function on? (see page 13.)Y Is the OVIDEO-2 SET� function setting correct?
(see page 14.)
Y If noise (snow) totally blocks out the picture,
Remote control inoperable
check the following.
Y Replace the batteries. (see page 3.)- Have the TV and aerial been connected properly?
- Has the aerial cable been damaged?
Buttons on front of the TV do not work- Is the aerial pointing in the right direction?
- Is the aerial itself faulty?
Y Switch the CHILD LOCK function off. (see page
13.)Y If the TV or aerial suffer interference from other
equipment, stripes or noise may appear in the
picture. Move any equipment which can cause
interference away from the TV.
TV does not respond immediately
Y If the TV or aerial suffer interference from
Y Press the main power button on the TV to turnsignals reflecting from mountains or buildings,
off the main power. Press the main power but-
double-pictures (ghosting) will occur. Change
ton again to turn on the TV. If the TV returns tothe aerialOs direction or replace it with an aerial
a normal state, operation is normal.
with better directionality.
Y When a white and bright still image (such as a
white dress) is displayed on the screen, the
The TV turns off suddenly
white part may look as if it is coloured. When
Y Is the OFF TIMER function set to operate? (seethe image disappears from the screen, the
page 9.)unnatural colours will also disappear.
Y Is the AUTO SHUTOFF function on? (see page
13.)
The picture is tilted
Y A picture may be tilted due to the influence of
Poor soundthe earthOs magnetism. In this case, use the PIC-
Y Press the SOUND SYSTEM button to select an-TURE TILT function to adjust the tilt. (see page
12.)
other sound system. (see page 8.)
Y Adjust the sound settings. (see page 14.)
Y If there is noise during mono sound output,
press the button to select OMONO�.
(see page 9.)
22
LCT1173-29W93-E72202.7.29, 11:52 AM |
ACEC
