Water outlet hose connectionElectrical connection
The end of the drain hose can be connected in the followingInformation concerning the electrical connection is given on the
ways: rating plate on the edge of the dishwasherOs door.
1.To the sink outlet spigot, securing it to the underside of the Before plugging the appliance into the wall socket, make sure
work surface. This will prevent waste water from the sink that:
running into the machine. 1.The mains voltage and current rating at the site of
2.To a stand pipe provided with vent-hole, minimum internal installation match the nominal voltage and current rating
diameter 4 cm. given on the rating plate.
The waste connection must be at a height of between 30 cm2.The meter, fuses, mains power supply and wall socket can
(minimum) and 100 cm (maximum) from the bottom of theall take the maximum load required. Make sure that the
dishwasher. socket and plug are compatible without having to use any
type of adaptor. If necessary, have the domestic wiring
The drain hose can face either to the right or left of the
dishwasher system socket replaced.
Ensure the hose is not bent or squashed as this could preventTo isolate the dishwasher from mains, remove the mains plug.
or slow down the discharge of water.
Important!
The sink plug must not be in place when the machine isThe plug must still be accessible after the appliance
draining as this could cause the water to syphon back into the
machine. has been installed.
In case that the electrical cable has to be replaced,
If you use a drain hose extension it must be no longer than 2please contact your local Service Force Centre.
metres and its internal diameter must be no smaller than the
diameter of the hose provided. The appliance should not be connected to the
electrical supply by means of an extension cable.
Safety standards require the appliance to be
earthed.
The manufacturer accepts no liability for failure to
observe the above safety precautions.
Likewise the internal diameter of the couplings used for
connections to the waste outlet must be no smaller than the
diameter of the hose provided.
Attention!
Our appliances are supplied with a security device to protect
against the return of dirty water back into the machine.
If the spigot of your sink has a "no return valve" incorporated
this can prevent the correct draining of your dishwasher.
We therefore advise you to remove it.
22 |