RIGGING
The FUSSION 1800SA and 1800S cabi-specified line voltage, the built-in amplifiers
nets are not designed for rigging or flying.will no longer be able to supply rated
The cabinets are for floor-mounting only.power. (They will continue to operate
down to 80% of the rated line voltage, but
WARNING: Never attempt to suspend thewonOt reach full power, resulting in lower
FUSSION 1800SA or 1800S loudspeakersheadroom.)
by their handles.Under maximum SPL conditions,
where musical peaks are just clipping, the
FUSSION 1800SA has the following cur-
rent requirements:
AC POWER
115V230V
The FUSSION 1800SA is shipped with a
Max. Continuous RMS10A6A
connector that mates with the AC recep-
Max. Peak 12A8A
tacle on the rear panel. Use heavy gauge
wire for the linecord to avoid power losses
Be sure the electrical service can supply
across the wire.
enough amperage for all the components
The following guide should be followed
connected to it.
when wiring a linecord:
We recommend that a stiff (robust) sup-
North America Internationalply of AC power be used because the
115VAC 230VACamplifiers place high current demands on
HotBlackBluethe AC line. The more power that is avail-
NeutralWhiteBrownable on the line, the louder the speakers will
Earth (Ground)Green w/ Greenplay and the more peak output power will
yellow stripebe available for cleaner, punchier bass. A
suspected problem of Opoor bass perfor-
mance� is often caused by a weak AC
NEUTRAL
WHITE (115V) OR
BROWN (230V)HOT supply to the amplifiers.BLACK (115V) OR
BLUE (230V)
20A.250V
Never remove the
20A.250V
MALEground pin on the power
NEUTRALFEMALEcord of the FUSSION
GROUNDWHITE (115V) OR
GREEN BROWN (230V)1800SA or any other
W/YELLOW GROUND
STRIPE (115V) GREEN component. This is very
or GREEN (230V)W/YELLOW
STRIPE (115V)
or GREEN (230V)dangerous.
HOT
BLACK (115V) OR
BLUE (230V)
AC Power Connectors
Be sure the FUSSION 1800SA is plugged
into an outlet that is able to supply the cor-
rect voltage specified for your model. If the
voltage should drop below 97% of the
8 |