DPS-6.5.book Page 14 Thursday, August 5, 2004 3:27 PM
Front & Rear PanelsNContinued
Rear Panel
123456 78 9 JK
AUDIO OUTPUT
FRONT/D. MIX12SURRCENTERDIGITCOAXIALALVIDEO OUTPUTREMOTE CONTROLIR
VIDEOIN
LýCOMPONENT 2COMPONENT 1AC INLET
SUPER AUDIO CD & DVD AUDIO/YPBPRYPBPRVIDEO PLAYERRS232
MODEL NO. DPS-6.5
RRAAC 120TING V 60Hz 11: W
WOSUBOFEROPTICALS VIDEOOUT
AAUDIO OUTPUT [20�21]FVIDEO OUTPUT [18]
These jacks output analog audio. The FRONT/These RCA connectors can be used to connect TVs,
D.MIX jacks can be connected to the stereo input on projectors or AV receivers with composite video
a TV, hi-Å¢ amp, or other component. The 1 and 2 inputs.
jacks output the same signals so you can use either. GS VIDEO OUTPUT [18]
DVDs with 5.1-channel audio are downmixed into
These connectors can be used to connect TVs or
two channels before being output by the FRONT/
projectors with S Video inputs.
D.MIX jacks.
H jacks [21]
If youOre using an AV receiver or surround decoder
These (Remote Interactive) connectors can be
with a 5.1-channel analog audio input, use the
connected to the connectors on your other Inte-
FRONT/D.MIX 1 or 2 jacks and the SURR L/R,
gra AV components for interactive control.
CENTER, and SUBWOOFER jacks. In this case,
For remote control operation, you must make an
you must set the Audio Output Mode on the Initial
analog RCA connection between your DPS-6.5 and
Setup menu to 5.1 Channel. With this setting, the
the other AV component, even if they are connected
FRONT/D.MIX jacks will output the front signals,
digitally.
and the SURR L/R, CENTER, and SUBWOOFER
jacks will output the surround, center, and sub-IIR IN/OUT [22]
woofer signals respectively.The IR IN connector can be used to connect a com-
mercially available IR receiver, which can be used
BCOAXIAL DIGITAL AUDIO OUTPUT [20]
to pickup signals from the remote controller when
This coaxial digital audio output can be connected
the DPS-6.5 is located in another room, installed in
to a coaxial digital audio input on a hi-Å¢ amp, AV
a rack, or is out of range of the remote controller
receiver, or surround sound decoder (Dolby Digital,
The IR OUT connector can be used to connect a
DTS).
commercially available IR emitter, which can be
COPTICAL DIGITAL AUDIO OUTPUT [20]
used to pass remote controller signals received by
This optical digital audio output can be connected to
the IR IN along to other AV components.
an optical digital audio input on a hi-Å¢ amp, AV
JRS 232
receiver, or surround sound decoder (Dolby Digital,
This RS-232 port can be connected to an external
DTS).
controller.
DCOMPONENT 2 VIDEO OUTPUT [19]
KAC INLET [23]
These BNC connectors can be used to connect a TV
The supplied power cord is connected here. The
or projector with BNC component video inputs.
other of the power cord should be connected to a
ECOMPONENT 1 VIDEO OUTPUT [19]
suitable wall outlet.
These RCA connectors can be used to connect a TV,
projector or AV receiver with component video
inputs.
14 |
ACEC
