%741@&OCPPL 1BHF 5VFTEBZ
.BZ
1.
Connecting the Power/Turning on the DV-SP501
Before connecting
Press STANDBY/ON on the DVD
� The DV-SP501 is shipped with the POWER switch in 3
Player or ON on the remote con-
the on position ( ON). When the power cord is STANDBY/ON
troller.
plugged in for the Ţrst time, the DV-SP501 will auto-
The DVD Player turns on and the
matically enter the standby state and the STANDBY
STANDBY indicator turns off.
indicator will light (same condition after step 2 STANDBY
�To put the DVD Player in the standby
below).
mode, press STANDBY/ON on the
� Make sure that all the connections on pages 18 � 22
DVD Player, or STANDBY on the
are complete (the connection to a TV is required).
remote controller. Be sure to set the
volume to minimum before putting
STANDBY/ONthe DVD Player in the standby mode
for the next use to avoid sudden loud
STANDBY/ONPAUSESTOPPLAYsound reproduction.
DISPLAY PLAY MODETOP MENUCURSORMENU
STPOWERANDBYDIMMERCLEARRETURNSETUP� While the STANDBY indicator
PUSHTOENTER
ONOFF
lights up, the DVD Player can
receive signals from the remote con-
POWERtroller. However, if you press
POWER on the DVD Player to
switch off the main power, the
Plug the supplied power cord
1remote controller cannot be used to
into the AC INLET and then into
turn on the DVD Player.
the power outlet on the wall.
� Setting the STANDBY button to
� Do not use a power cord other than
standby does not shut off the power
the one supplied with the DV-SP501.
completely.
The power cord supplied is designed
for use with the DV-SP501 and
Note:
should not be used with any other
� This player features a screen saver and an auto power
device.
off function. If the player is stopped and no button is
�Never have the power cord discon-
pressed for Ţve minutes, the screen saver starts. If the
nected from the DV-SP501 while the
disc tray is closed but no disc is playing and no control
other end is plugged into the wall
is pressed for 30 minutes, the player automatically
outlet. Doing so may cause an elec-
goes into standby.
tric shock. Always connect by plug-
ging into the wall outlet last and
disconnect by unplugging from the
wall outlet Ţrst.
AC INLET
To a wall outlet
Press POWER to switch on the
2
main power.
POWER
The DVD Player enters standby mode.
ONOFFThe STANDBY indicator lights up.
� The buttons on the remote controller
do not operate if the POWER switch
is set to OFF.
�To switch off the main power, press
POWER again.
23 |
ACEC
