Setting and Changing of theR/L cut: About one-third of both the right and left
Setting (Halogen Mode, portions of the screen are excluded from mea-
surement.
Fluorescent Mode, Outdoor Mode)
1 Brightness Set Display
1. Video Level Adjustment [Picture Level: �50 to +50]
Convergence level of AUTO IRIS/AUTO GAIN UP/4. Auto ND (ELC) Setting [Auto ND (ELC): ON, OFF]
AUTO ND (ELC) can be adjusted.This cannot be set unless either OOFF� or OAuto� has
2. Detecting Ratio Adjustment been set for the CCD storage time setting (1-9).
[Light PEAK/AVG: P50 to A50]ON: The electronic shutter is controlled to automati-
The ratio of AUTO IRIS/AUTO GAIN UP/AUTO NDcally adjust the luminance.
OFF: Luminance is not automatically adjusted by the
(ELC) detected peak to average can be adjustedelectronic shutter.
within a predetermined range.
3. Photometric Measurement Method Setting Notes
Y ON is automatically selected when the electronic
shutter (5-2) on the submenu [Other Set] is set to[Light Area: All, Center, Top cut, BTM cut, R/L cut]
[Auto ND]. OFF is selected when other than [AutoA photometric measurement method can be selected
for AUTO IRIS/AUTO GAIN UP/AUTO ND (ELC).
ND] is selected.All: All the screen area is measured.
Y ON is selected when the SHUTTER switch is setCenter: The screen is measured mainly in the center
to [ELC] in RCU (RCB) mode, and OFF is select-
ed when it is set to other than [ELC].area, about one-third of both the top and bottom
and one-third of both the right and left portions of
the screen are excluded from measurement.
Top cut: About one-third of the top part of the screen
is excluded from measurement.
BTM cut: About one-third of the bottom portion of the
screen is excluded from measurement.
SHUTTER Switch
RCU (RCB)
-34- |
ACEC
