Danger of kickback. The blade is capable
Danger of flying debris.
of amputating arms and legs.
CAUTION!
Danger of serious leg injuries. Take
15 mMinimum safety distance 15m.
scrupulous care to follow the instructions
in the manual.
CAUTION!
The cutting parts and muffler may get
Emergency stop.
very hot and cause burns. Wait a few
minutes before touching them.
Maximum shaft speed.
Prior to useresistant to cuts and vibrations. d) Safety visor or
? Do not use this machine for any other purpose than that protective goggles. Remove the protective film if any. e)
for which it was designed, using the proper cutting Hearing protection. The use of personal protection gear
devices as indicated in the instructions.does not eliminate the risk of injury but may reduce the
? B1. Anyone who uses the machine should have read effect of the damage in case of accidents.
the entire manual with extreme care.? Do not wear loose clothing or jewelry that could get
? Make sure you know how to stop the engine and blade caught in the moving parts of the machine.
if necessary (see section entitled ?Starting and stopping ? Watch out for the rotating parts and hot surfaces of the
the engine?).machine.
? All users should be familiar with the operations for use
Health precautions
of the machine under absolutely safe conditions as
described in this manual, and should be instructed in CAUTION! Avoid prolonged use. Noise and
the proper cutting techniques to use, possibly by vibrations may be dangerous.
practical demonstration.? Prolonged use of the machine or other equipment
? Do not use the machine if you are tired, in poor health expose the operator to vibrations that can cause the
or under the effects of alcohol or medication that could White Finger Syndrome (Syndrome of Raynaud). This
affect your reactions.could reduce the sensitivity of the hands in
? Do not allow children or persons who are not familiar distinguishing different temperatures and cause a
with these instructions and are not sufficiently trained to general numbness. The operator should therefore
use the brush cutter. Local regulations may specify an check the conditions of the hands and fingers if the
age limit for users.machine is used continuously or regularly. If one of the
? Keep this manual with the machine when selling or symptoms should appear, consult a doctor
lending it, to enable the future users to familiarize immediately.
themselves with the product and instructions for safe ? Prolonged use of the machine or other equipment can
use.cause discomfort, stress, fatigue, hearing damage.
? Always inspect the machine carefully prior to use: make Wear suitable hearing protection when using the
sure it is correctly assembled and that there are no machine. Correct and scrupulous maintenance can
loose screws, damaged parts, fuel leaks.also help to protect you further from the risk of noise
? Replace any accessories (blades, nylon string heads, and vibration.
guards) which show damage or cracks or appear ? Never start or run the engine in a closed or poorly
excessively worn. Have your Authorized Service ventilated place.
Center replace any damaged parts.
CAUTION! The exhaust fumes are toxic if
? Perform all operations of maintenance and/or assembly inhaled, and may cause asphixiation and even
ONLY with the engine off and wearing gloves.death.
Apparel
Work zone
? B2. Dress suitably for the job; wear approved personal
? Examine the work area and be careful of any hazards
protection gear: a) Close-fitting clothing (no shorts or (such as roads, driveways, power lines, hanging tree
loose clothes). b) Safety boots with non-slip sole,
limbs, etc.).
crush-resistant toe cap and protection against cuts (do
not wear sandals or work barefoot). c) Sturdy gloves
2-ENGLISH |