wCheck that the mode selector on the side of the remote control is set to TV.
Adjusting the sound
& Press H, select the SOUND option (J) andDescription of the settings:
press L.The SOUND menu appears :Y LEVEL: to balance the sound between the
different speakers (see below).
SOUNDY EQUALIZER: to adjust the sound tone (from
Y PICTURE
Y SOUNDY LEVEL120 HZbass: 120 Hz to treble: 10 kHz).
Y FEATURESY EQUALIZER500 HZ
Y INSTALLY SURROUND MODE 1500 HZY SURROUND MODE: to select the different
Y DELTA VOLUME5 KHZ
surround modes (see next page).
Y STORE10 KHZ
Y AVLY DELTA VOLUME (volume difference):allows
Y CORDLESS
you to compensate for the volume differences
Y DELAY
between the different programmes or the EXT
é Use IJ keys to select a setting and keyssockets.This setting is available for
KLto adjust.programmes 1 - 40 and the EXT sockets.
Note:to access the AVL,CORDLESS and DELAYY STORE: stores the sound settings.
settings (hidden at the bottom of the screen) holdY AVL (Automatic Volume Leveller): automatic
down J key.The CORDLESS and DELAY settingsvolume control used to avoid sudden
are only availables if surround loudspeakers areincreases in volume, particularly when
connected to the TV set.The DELAY setting onlychanging programmes or during
appears in DOLBY PRO LOGIC and HALLadvertisements.
SURROUND modes.Y CORDLESS:to adjust the different parameters
Ť Once the necessary adjustments have beenof the cordless surround speakers (see p.17).
made, select the option STORE and press LY DELAY: to adjust the delay of surround effect
to store them.on the rear loudspedakers (31 is the default
Ź To exit from the menus, press R.value).
Adjusting the sound level
This menu allows you to balance the sound(depending on the selected surround mode).
between the different speakers.Remark :the rear channel only appears if surround
& Press H, select SOUND (J) and press L.speakers are connected to the TV set.To change
The SOUND menu appears :the surround mode,press the ) key.
Ť Select BALANCE, CENTRE or REAR and use
SOUND
the KL keys to adjust the level of each
Y PICTURE
Y SOUNDchannel independently.The sequence stopsY LEVELTEST
Y FEATURESY EQUALIZERBALANCE
Y INSTALL
Y SURROUND MODE CENTREwhile the level is being changed and then
Y DELTA VOLUMEREAR
automatically starts up again.
Y STORE
Y AVLŹ To stop the test, press H.
Y CORDLESS
DELAYLevels may also be adjusted without using the test
signal.
é Select TEST and press L to set it to ON.( To exit from the menus, press R.
A continuous sound is emitted in turn from
each channel : left, right, centre and rear
8 |
ACEC
