Dual screen / PIP / Multipip
Press the PIP button to switch on Dual screen,PIP or one of the PIP modes
according to the format selection made in the PIP format list in the General
menu. See Settings, General, p. 8.
Press the PIP button again.The screen that has a yellow border will become
POWER
the full main screen picture.
DVD/R CBL TV VCR AUXNotes:
- Continuing to hold the PIP button down will cycle the TV through the various
?o
formats (Dual screen,PIP,PIP 3 or PIP6),launching a new format after each second
INFOSELECTPIXEL PLUS
the button is held down.After standby of the TV,the preference as set in the
OA?
Settings,General menu is used.
TVCCSURRHD
- It is not possible to display a HDMI or HD source in a Dual screen/PIP screen.
SCREEN
- When Dual screen mode is selected,two picture formats are supported:Full screen
SURFFORMAT
or 4:3 letterbox picture format (vertical squeeze).
?
- Audio from the right screen or the PIP plays to the headphones.
??
OKDisplay options
?Dual screenPIPPIP 3PIP 6
AUXPIP1PIP1PIP4
PIPMENUMENU
AUXPIP2PIP2PIP5
PIP3PIP3PIP6
++
VOLMUTECH
YPress the cursor right to highlight the right screen.
--YPress the cursor down to highlight the single PIP screen.
YPress the cursor right to enter the Multipip screen and then use the cursor
123buttons to navigate through the PIP screens and to highlight a PIP screen.
6
Changing TV channels or external sources in left, right, PIP or
Multipip screen
YPress the -CH+ buttons or the SURF button or the digit buttons in order
to change the TV channels or external sources in the highlighted screen.
Scan PIP3 or PIP 6
Navigate to the lowest PIP and press the cursor down to display a
following series of PIP screens.
Define the position and the size of the single PIP screen
&Select a Dual screen mode with a single PIP screen.
éPress the cursor down to highlight the PIP screen.A PIP menu appears with
which you can define the position and the size of the PIP screen.
Note:When the PIP menu times out,press the OKbutton to make it reappear.
ŤPress the cursor down again to select Positionor Size.
ŹPress the OKbutton or the cursor right to activate.
(Use the cursor buttons to define the position of the PIP screen.Use the
cursor left/right to define the size of the PIP screen.
§Press the OKbutton.The PIP menu reappears.
ePress the cursor up to the top of the menu to highlight the main screen
again.
!Press the OKbutton to switch off the menu or wait until it is timed out.
On-Screen information
The highlighted On-Screen information,which appears when changing
channels, always refers to the active screen.
16 |
ACEC
