2558.1._austr.qxd 08-08-2006 16:05 Pagina 53
TroubleshootingEN
SymptomPossible cause/Remedy
No picture<Verify if the supplied cables are connected properly.(The aerial cable to the
TV, the other aerial to your recorder, the power cables, ..)
<Verify if you selected the correct source.
<Verify if the child lock has been switched off.
Poor picture<Verify in the Manual installation menu if you have selected the correct TV
system.
<Verify if your TV or house aerial isn't located too close to loudspeakers,
non-earthed audio equipment or neon lights, etc.
<Mountains or high buildings can cause double pictures or ghost images.
Sometimes you can improve the picture quality by changing the direction of
the aerial.
<Is the picture or teletext unrecognisable or do you experience bad teletext
reception ? Verify if you have entered the correct frequency, or fine tune the
frequency for that specific channel or adjust the antenna direction if the problem
isnOt solved by finetuning. See Installation,Analogue: manual installation, p. 30.
Poor colour<Select Factory settings in the Installation menu.
<Verify the connections between the optional equipment and the TV.
No sound<Verify if the volume isn't at minimum.
<Verify if the sound hasn't been muted with the ?key.
Verify the connections between the optional equipment and the TV.
No digital channels <Contact your dealer about Digital Terrestrial transmission signal availability in your
country.
The remote does<Verify if the remote is set correctly for the equipment your are using.
not function<Verify if the batteries are not dead.Replace the batteries.
You can still use the keys at the left side of the TV.
<Select TVmode on your remote control.
<When pressing a key and some key leds are blinking with a higher speed and lower
intensity than in a normal working condition, and your TV does not react on the
key press, remove the batteries out of the remote control and put them back again.
The remote of<The infrared signals of the screen may influence the reception sensibility
connected equip-of other peripherals.
ment does notSolution: replace the batteries of the remote of other peripheral
function wellequipment.
No photo or music<Verify if the source complies with a supported code.
play or in poor
quality
No stable or not<Verify if you have selected the correct VGA mode in your PC.
synchronised VGASee Connect a PC, p. 49.
picture<Verify the connections between the TV and the PC.
No solution found<Switch off your TV off and then on again once.
for your picture orNever attempt to repair a defective TV yourself.
sound problemVerify with your dealer or call a TV technician.
Red blinking led<Unplug the mains cord for 10 seconds and insert it in again.
53 |
ACEC
