24ENGLISHENGLISH25
8You may also clean the hair chamberDo not clean more than one cutter and comb at
without water by using the supplied brush.a time, since they are all matching sets. If you
accidentally interchange the cutters and combs, it
Once A Month: Razor Headscould take several weeks before optimal shaving
performance is restored.
Do not mix up the cutters and combs as the
shaving performance may be adversely affectedC6Replace the set back into the Razor Head
for several weeks before optimal shavingAssembly so that the �wingsO on the comb
performance is restored.fit within the brackets located towards the
center of the Assembly.
1Turn razor OFF, remove the charging plugThe set will only fit into the Razor Head Assembly
from the outlet and cord from the razorif the �wingsO are between the brackets. Make sure
or charging stand.that the two pointy edges of the head fit exactly
into the recesses.
C2Press the razor head release button to
open the razor head assembly.7Repeat the process for the other two sets
of cutters and combs.
C3Turn the wheel counterclockwise (1) and
remove the retaining frame (2).8Replace the frame.
C9Press down (1) and turn wheel clockwise
(2) until it locks into place.
C4Remove and clean one set of cutters and10Close the Razor Head Assembly.
combs at a time.
Once A Month: Razor Heads
For optimum performance, razor cutters and
combs should be cleaned in a degreasing liquid
C5Separate the cutter from the comb and(e.g. Philips Norelco Razor Cleaner, model
rinse clean under hot water.RC1776, or rubbing alcohol) and lubricated with
Philips Norelco Razor Lubricant, model AL80, or
one drop of mineral oil (in the center of the
head). This helps prevent wear of the shaving
heads. |
ACEC
